Difficulty

Moderate

Steps

10

Time Required

                          15 - 25 minutes

Sections

3

  • Front Panel
  • 5 steps
  • Speed Adjustment Assembly
  • 3 steps
  • Motor
  • 2 steps

Flags

0

  • BackWen 2307

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Front Panel
  • Unscrew the locking sleeve.

Unscrew the locking sleeve.

1024

Step 2

  • Remove the hanging clip.

Remove the hanging clip.

Step 3

  • Unscrew the six 8mm PH2 screws.

Unscrew the six 8mm PH2 screws.

Step 4

  • While pressing the spindle lock button, unscrew the collet nut and remove it along with the brass collet.

While pressing the spindle lock button, unscrew the collet nut and remove it along with the brass collet.

Step 5

  • To remove the front panel, pry the device apart while holding the device with the other hand.
  • The front panel should come out easily.

To remove the front panel, pry the device apart while holding the device with the other hand.

The front panel should come out easily.

Step 6

              Speed Adjustment Assembly
  • Remove the connected wiring from the circuit board.

Remove the connected wiring from the circuit board.

Step 7

  • Remove the single 4mm screw retaining the circuit board.

Remove the single 4mm screw retaining the circuit board.

Step 8

  • Gently pry the circuit board from the back piece.

Gently pry the circuit board from the back piece.

Step 9

              Motor
  • Gently pull motor assembly out of the panel.

Gently pull motor assembly out of the panel.

Step 10

  • Motor separates into two pieces.

Motor separates into two pieces.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Joshua Bowery

Member since: 02/08/2016

549 Reputation

                                      3 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       USF Tampa, Team 12-1, Eyestone Spring 2016                        

                                                  Member of USF Tampa, Team 12-1, Eyestone Spring 2016 



                    USFT-EYESTONE-S16S12G1                     


                                            4 Members                     


                                            6 Guides authored

Closetslave 1 - May 12, 2021

Reply

All very well and good, but it’s impossible to buy the motor parts to replace…