Difficulty
Easy
Steps
2
Time Required
5 minutes
Sections
1
- Pressure Regulator Knob
- 2 steps
Flags
0
BackWEN 18 Gauge 2-Inch Air Brad Nailer
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Pressure Regulator Knob
- Using a 2mm Allen wrench, remove the Allen screw located on the pressure regulator knob on the back of the brad nailer.
Using a 2mm Allen wrench, remove the Allen screw located on the pressure regulator knob on the back of the brad nailer.
1024
Step 2
- Remove the knob from the gun and replace the knob.
- Be aware of the rubber spacer that will come off with the knob; when you replace the knob put the spacer back in the middle around the screw hole.
Remove the knob from the gun and replace the knob.
Be aware of the rubber spacer that will come off with the knob; when you replace the knob put the spacer back in the middle around the screw hole.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Ousman Jammeh
Member since: 09/17/2018
507 Reputation
3 Guides authored
Badges:
5
+2 more badges
Team
Washington State, Team S1-G3, Hope Fall 2018
Member of Washington State, Team S1-G3, Hope Fall 2018
WSU-HOPE-F18S1G3
4 Members
3 Guides authored
