Difficulty
Very easy
Steps
4
Time Required
10 - 15 minutes
Sections
2
- Back Panel
- 3 steps
- Plastic Leg and Rubber Stoppers
- 1 step
Flags
0
BackWaring Pro SB30
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Remove the screws on the back panel with the #1 Phillips screwdriver bit.
- The screws in the rubber legs of the burner do not need to be removed.
- If the back panel has never been opened before, the screws may be more difficult to unscrew.
Remove the screws on the back panel with the #1 Phillips screwdriver bit.
The screws in the rubber legs of the burner do not need to be removed.
If the back panel has never been opened before, the screws may be more difficult to unscrew.
1024
Step 2
- Using a wrench, remove the bolt from the center of the back panel.
Using a wrench, remove the bolt from the center of the back panel.
Step 3
- The back panel can now be easily lifted off.
The back panel can now be easily lifted off.
Step 4
Plastic Leg and Rubber Stoppers
- While using the wrench to hold the bolt, use the screwdriver to remove the screw.
- The leg is two separate pieces, the plastic leg and rubber stopper.
- Careful not to lose the bolts and washers as they are very small.
While using the wrench to hold the bolt, use the screwdriver to remove the screw.
The leg is two separate pieces, the plastic leg and rubber stopper.
Careful not to lose the bolts and washers as they are very small.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Sun Fai Lau
Member since: 09/22/2014
588 Reputation
5 Guides authored
Badges:
10
+7 more badges
Team
USF Tampa, Team 10-7, Brown Fall 2014
Member of USF Tampa, Team 10-7, Brown Fall 2014
USFT-BROWN-F14S10G7
3 Members
5 Guides authored
