Difficulty

Difficult

Steps

9

Time Required

                          20 minutes            

Sections

4

  • Bottom Panel
  • 2 steps
  • Drive Coupling
  • 3 steps
  • Motor
  • 3 steps
  • Power Cord
  • 1 step

Flags

0

  • BackWaring 51BL29

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Bottom Panel               
  • Turn the blender on its side so the bottom panel is facing you.
  • Unscrew the 22mm Phillips #1 screw on the indent of the panel.
  • Unscrew the 3 screws in the rubber holes.

Turn the blender on its side so the bottom panel is facing you.

Unscrew the 22mm Phillips #1 screw on the indent of the panel.

Unscrew the 3 screws in the rubber holes.

1024

Step 2

  • Remove the bottom panel.

Remove the bottom panel.

Step 3

              Drive Coupling               
  • Place the screwdriver in the head of the middle flat-head screw.

Place the screwdriver in the head of the middle flat-head screw.

Step 4

  • Unscrew this screw while holding the coupling with your other hand and not allowing it to rotate.
  • This screw may be reverse-threaded.

Unscrew this screw while holding the coupling with your other hand and not allowing it to rotate.

This screw may be reverse-threaded.

Step 5

  • Once the coupling mechanism has been loosened all the way, gently pull it off the top of the blender.

Once the coupling mechanism has been loosened all the way, gently pull it off the top of the blender.

Step 6

              Motor               
  • Unscrew the four nuts in the bottom of the motor cavity.
  • Wiggle the motor until it is free and you can remove it.

Unscrew the four nuts in the bottom of the motor cavity.

Wiggle the motor until it is free and you can remove it.

Step 7

  • Once motor is pulled out, unscrew the 8 mm screw for the green wire from the base of the blender.

Once motor is pulled out, unscrew the 8 mm screw for the green wire from the base of the blender.

Step 8

  • Unscrew each white wire cap in order to free the motor from the power cord.
  • Once wire caps are removed, separate wires carefully.

Unscrew each white wire cap in order to free the motor from the power cord.

Once wire caps are removed, separate wires carefully.

Step 9

              Power Cord               
  • Remove the black power cord.

Remove the black power cord.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Quinn Vu                     

Member since: 04/17/2017

110 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       Cal Poly, Team S15-G4, Banghart Spring 2017                        

                                                  Member of Cal Poly, Team S15-G4, Banghart Spring 2017 



                    CPSU-BANGHART-S17S15G4                     


                                            4 Members                     


                                            5 Guides authored