Difficulty
Moderate
Steps
4
Time Required
10 minutes
Sections
1
- Motor
- 4 steps
Flags
0
BackWahl Professional Designer
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Motor
- Unscrew the 12 mm Phillips head screws located at the top of the cover and at the bottom two corners, using a Phillips #1 Screwdriver.
Unscrew the 12 mm Phillips head screws located at the top of the cover and at the bottom two corners, using a Phillips #1 Screwdriver.
1024
Step 2
- Remove the wires connected to the motor by firmly grasping both sides of a wire and wiggling until it is released.
Remove the wires connected to the motor by firmly grasping both sides of a wire and wiggling until it is released.
Step 3
- Unscrew the two 20.5 mm Phillip head screw located on the motor using a Phillip’s #1 screwdriver.
Unscrew the two 20.5 mm Phillip head screw located on the motor using a Phillip’s #1 screwdriver.
Step 4
- Gently remove the motor from the device.
Gently remove the motor from the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Sophia Swearengin
Member since: 09/26/2017
694 Reputation
5 Guides authored
Badges:
8
+5 more badges
Team
USF Tampa, Team S14-G5, Boczar Fall 2017
Member of USF Tampa, Team S14-G5, Boczar Fall 2017
USFT-BOCZAR-F17S14G5
2 Members
5 Guides authored