Difficulty
Easy
Steps
11
Time Required
10 minutes
Sections
2
- Case
- 8 steps
- Power Switch
- 3 steps
Flags
1
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
BackWahl Chrome Pro
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Case
- Remove the two 5.0 mm JIS #1 screws to loosen the cutting blades.
- Make sure your device is not connected to power before you begin.
Remove the two 5.0 mm JIS #1 screws to loosen the cutting blades.
Make sure your device is not connected to power before you begin.
1024
Step 2
- Lift the bottom blade straight up from the device body to remove it.
Lift the bottom blade straight up from the device body to remove it.
Step 3
- Remove the three 9.0 mm JIS #1 screws attaching the base of the blade assembly to the body.
Remove the three 9.0 mm JIS #1 screws attaching the base of the blade assembly to the body.
Step 4
- Lift the base of blade assembly straight up off of the body.
Lift the base of blade assembly straight up off of the body.
Step 5
- Remove the two 12.0 mm JIS #1 screws on the back of the device body.
Remove the two 12.0 mm JIS #1 screws on the back of the device body.
Step 6
- Remove the 13.0 mm Phillips #2 screw on the side of the device body.
- This screw is located on the opposite side of the body from the switch.
Remove the 13.0 mm Phillips #2 screw on the side of the device body.
This screw is located on the opposite side of the body from the switch.
Step 7
- Remove the spring on the side of the body using tweezers.
Remove the spring on the side of the body using tweezers.
Step 8
- Pry the body case off of the device using a spudger.
Pry the body case off of the device using a spudger.
Step 9
Power Switch
- Remove one 7.5 mm JIS #1 screw connecting the power cord to the switch base.
Remove one 7.5 mm JIS #1 screw connecting the power cord to the switch base.
Step 10
- Remove one 7.5 mm JIS #1 screw connecting the wire to the switch base.
Remove one 7.5 mm JIS #1 screw connecting the wire to the switch base.
Step 11
- Remove the switch from device by lifting straight up from the device body.
Remove the switch from device by lifting straight up from the device body.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Holly Dunn
Member since: 11/09/2017
101 Reputation
1 Guide authored
Badges:
2
Team
IUPUI, Team S7-G3, Baechle Fall 2017
Member of IUPUI, Team S7-G3, Baechle Fall 2017
IUPUI-BAECHLE-F17S7G3
3 Members
4 Guides authored