Difficulty

Moderate

Steps

10

Time Required

                          15 - 30 minutes

Sections

1

  • Battery
  • 10 steps

Flags

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

  • BackWacom Intuos CTL4100

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

If your battery is swollen take appropriate precautions. Be sure to power off your device and unplug from any external power prior to beginning the repair.

What you need

Step 1

              Battery
  • Flip the tablet over so the bottom case faces upwards.
  • Remove the rubber pads on the corners by pulling them up with your fingers.

Flip the tablet over so the bottom case faces upwards.

Remove the rubber pads on the corners by pulling them up with your fingers.

1024

Step 2

  • Remove the 4 mm Philips screws on the four corners using a Phillips screwdriver #00.

Remove the 4 mm Philips screws on the four corners using a Phillips screwdriver #00.

Step 3

  • Insert a plastic opening pick between the front and back case to unclip the clips that hold the cases together.
  • Slide your plastic opening pick around the sides until all clips are unclipped.

Insert a plastic opening pick between the front and back case to unclip the clips that hold the cases together.

Slide your plastic opening pick around the sides until all clips are unclipped.

Step 4

  • Lift the bottom case to separate the top and bottom case
  • When you see the internal components, set aside the bottom case.

Lift the bottom case to separate the top and bottom case

When you see the internal components, set aside the bottom case.

Step 5

  • Remove the yellow tape that is on top of the battery wires.
  • When the battery wires under the tape are exposed, stick the yellow tape just above the battery wires.

Remove the yellow tape that is on top of the battery wires.

When the battery wires under the tape are exposed, stick the yellow tape just above the battery wires.

Step 6

  • Gently pull up the battery wire pin with your fingers to disconnect the pin from the motherboard.

Gently pull up the battery wire pin with your fingers to disconnect the pin from the motherboard.

Step 7

  • Remove the battery by lifting the battery up with your fingers.

Remove the battery by lifting the battery up with your fingers.

Step 8

  • Place the new battery on the area you removed the battery.

Place the new battery on the area you removed the battery.

Step 9

  • Gently connect the battery wire pin to the motherboard.

Gently connect the battery wire pin to the motherboard.

Step 10

  • Reapply the tape you put above the battery wires.

Reapply the tape you put above the battery wires.

To reassemble your device, follow step 4 in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 2 other contributors 


                    Marcus Sisouphanh

Member since: 09/11/2021

262 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       York University, Team 1-24, O'Regan Fall 2021                        

                                                  Member of York University, Team 1-24, O'Regan Fall 2021 



                    YORK-O'REGAN-F21S1G24                     


                                            1 Member                     


                                            1 Guide authored

David VeLar - May 19, 2022

Reply

Where did you get the replacement battery?