Difficulty
Easy
Steps
2
Time Required
Suggest a time??
Sections
1
- Power Supply
- 2 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackWacom Cintiq 24HD
Full Screen
Options
History
Save to Favorites
Download PDF
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Power Supply
- Procurement of a suitable commercially available power pack.
- Type GST120A24R7B
- R7B is important as this is the only connector that fits the Wacom tablet. (Connector type KYCON KPPX-4).
- Performance data 120W, 24 volts
- The power pack opens. To do this, the four rubber plugs are removed and the four screws are removed with a Phillips screwdriver. The housing can then be easily removed.
- The 24V side has four wires: black, blue, red and white. These are soldered and can be removed.
- The black and blue wire is soldered to the minus output (V-). The red and white wire is soldered to the 24V (V+) output. Note: The black wire is connected to the metal body of the plug.
- The power supply will reassemble and can now be connected to the Wacom Tablet.
Procurement of a suitable commercially available power pack.
Type GST120A24R7B
R7B is important as this is the only connector that fits the Wacom tablet. (Connector type KYCON KPPX-4).
Performance data 120W, 24 volts
The power pack opens. To do this, the four rubber plugs are removed and the four screws are removed with a Phillips screwdriver. The housing can then be easily removed.
The 24V side has four wires: black, blue, red and white. These are soldered and can be removed.
The black and blue wire is soldered to the minus output (V-). The red and white wire is soldered to the 24V (V+) output. Note: The black wire is connected to the metal body of the plug.
The power supply will reassemble and can now be connected to the Wacom Tablet.
1024
Step 2
- Test: According to the assignment in the picture, after resoldering the lines, the ground line must be on the upper 2 pins and the +24V voltage on the lower 2 pins
Test: According to the assignment in the picture, after resoldering the lines, the ground line must be on the upper 2 pins and the +24V voltage on the lower 2 pins
Work the steps in reverse order to reassemble your device.
Cancel: I did not complete this guide.
HelloMacOS is helping us fix the world! Want to contribute? Start translating ›
Special thanks to these translators:
100%
HelloMacOS
Author
with 1 other contributor
Wilfried Weigelt
Member since: 02/29/2020
85 Reputation
1 Guide authored
Badges:
1