Difficulty

Moderate

Steps

11

Time Required

                          15 - 30 minutes

Sections

4

  • Flex Shaft
  • 1 step
  • Housing Separation
  • 3 steps
  • Power Cable Disconnection
  • 2 steps
  • Power Cable
  • 5 steps

Flags

0

  • BackWacker Concrete Vibrator M1500/120 - REV 100 (2016)

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Disconnect the flex shaft
  • Before starting, ensure the device is unplugged from power.
  • Pull up on the quick-disconnect handle to release the lock on the flex shaft.
  • Remove the flex shaft.

Before starting, ensure the device is unplugged from power.

Pull up on the quick-disconnect handle to release the lock on the flex shaft.

Remove the flex shaft.

1024

Step 2

              Remove the housing screws
  • Use a T20 Torx screwdriver to remove the nineteen screws securing the two halves of the device housing.

Use a T20 Torx screwdriver to remove the nineteen screws securing the two halves of the device housing.

Step 3

              Remove the dust filter
  • Lay the device down onto its right side, screw holes facing up.
  • Remove the rear dust filter.

Lay the device down onto its right side, screw holes facing up.

Remove the rear dust filter.

Step 4

              Separate the halves
  • Lift to remove the left half of the device housing.
  • If the housings feel stuck together, use a flathead screwdriver to create a gap between the halves.

Lift to remove the left half of the device housing.

If the housings feel stuck together, use a flathead screwdriver to create a gap between the halves.

Step 5

              Lift up the switch
  • Lift the switch out of its recess in the case housing.

Lift the switch out of its recess in the case housing.

Step 6

              Disconnect the power wires
  • Use a pair of needle nose pliers to disconnect the black and white power wires from their terminals on the switch.

Use a pair of needle nose pliers to disconnect the black and white power wires from their terminals on the switch.

Step 7

              Remove the power cable clamp
  • Use a T20 Torx screwdriver to remove the two screws securing the power cable clamp to the housing.

Use a T20 Torx screwdriver to remove the two screws securing the power cable clamp to the housing.

Step 8

  • Remove the power cable clamp.

Remove the power cable clamp.

Step 9

              Remove the power cable assembly
  • Lift the power cable assembly up and away from the device.

Lift the power cable assembly up and away from the device.

Step 10

              Remove the reinforcing sleeve
  • Slide the reinforcing sleeve up and off of the power cable.

Slide the reinforcing sleeve up and off of the power cable.

Step 11

  • Only the power cable remains.

Only the power cable remains.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                    Carsten Frauenheim

Member since: 03/10/2020

81,713 Reputation

                                      330 Guides authored                  



                       Badges:
                       38







                                                        +35 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,772 Guides authored