Difficulty

Moderate

Steps

6

Time Required

                          30 minutes

Sections

3

  • Wacker Compactor Plate VP1550AW 2014 Safety Precautions
  • 1 step
  • Wacker Compactor Plate VP1550AW 2014 V-Belt Guard Removal
  • 2 steps
  • V-Belt
  • 3 steps

Flags

0

  • BackWacker Compactor Plate VP1550AW (2014)

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Safety precautions
  • Before you begin, be sure that the engine is powered off and is cool to the touch.
  • Grab the plastic housing at the end of the spark plug wire.
  • Pull firmly to disconnect the wire from the spark plug.

Before you begin, be sure that the engine is powered off and is cool to the touch.

Grab the plastic housing at the end of the spark plug wire.

Pull firmly to disconnect the wire from the spark plug.

1024

Step 2

              Loosen the belt guard
  • Use a 1/2" socket and wrench to loosen the two bolts securing the belt guard.
  • The bolts are captive and should not be removed.

Use a 1/2" socket and wrench to loosen the two bolts securing the belt guard.

The bolts are captive and should not be removed.

Step 3

              Remove the belt guard
  • Remove the belt guard.

Remove the belt guard.

Step 4

              Remove the drive belt
  • Use scissors or a blade to cut the drive belt.
  • Remove the drive belt.

Use scissors or a blade to cut the drive belt.

Remove the drive belt.

Step 5

              Install a replacement belt
  • Loop the replacement belt onto the small pulley.

Loop the replacement belt onto the small pulley.

Step 6

  • Replacing the belt poses a substantial pinching hazard. Wear safety gloves and be mindful where you position your fingers.
  • Guide the belt over the top of the clutch pulley.
  • Loop the belt underneath the pulley axle.
  • Rotate the pulley slowly and guide the built into the groove.
  • Getting the replacement belt back onto the drive pulley requires considerable strength.

Replacing the belt poses a substantial pinching hazard. Wear safety gloves and be mindful where you position your fingers.

Guide the belt over the top of the clutch pulley.

Loop the belt underneath the pulley axle.

Rotate the pulley slowly and guide the built into the groove.

Getting the replacement belt back onto the drive pulley requires considerable strength.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Arthur Shi

Member since: 01/03/2018

211,868 Reputation

                                      442 Guides authored                  



                       Badges:
                       46







                                                        +43 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,769 Guides authored