Difficulty

Difficult

Steps

6

Time Required

                          35 minutes

Sections

3

  • Battery
  • 2 steps
  • Motor
  • 2 steps
  • Power Switch
  • 2 steps

Flags

2

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackVtech Move and Crawl Ball

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • There are two screws that require a 4.0mm flat head screwdriver. Twist them counter clockwise to remove. When you remove them they stay contained within the blue outer case.

There are two screws that require a 4.0mm flat head screwdriver. Twist them counter clockwise to remove. When you remove them they stay contained within the blue outer case.

1024

Step 2

  • Pry the batteries out with your finger. When you replace them be sure to orient them correctly according to the markings in the slots. Match the plus symbol on the battery to the plus symbol in the slot.

Pry the batteries out with your finger. When you replace them be sure to orient them correctly according to the markings in the slots. Match the plus symbol on the battery to the plus symbol in the slot.

Step 3

              Motor
  • Remove 6 screws in order to pop off the outer shell and reach the inside components.

Remove 6 screws in order to pop off the outer shell and reach the inside components.

Step 4

  • Remove the motor by lifting it out of the shell, and find the attached wires at both ends: the circuit board and the motor itself. Use the soldering iron to remove the existing attachments by heating the solder joint with the solder iron tip while pulling on the wire.
  • Make sure the motor is aligned over the correct holes during reassembly.

Remove the motor by lifting it out of the shell, and find the attached wires at both ends: the circuit board and the motor itself. Use the soldering iron to remove the existing attachments by heating the solder joint with the solder iron tip while pulling on the wire.

Make sure the motor is aligned over the correct holes during reassembly.

Step 5

              Power Switch
  • Unscrew the two screws to the power switch located beside the circuit board

Unscrew the two screws to the power switch located beside the circuit board

Step 6

  • Remove the existing attachments at both ends of the wires with the soldering iron. Heat the solder joint with the solder iron tip and pull the wire.

Remove the existing attachments at both ends of the wires with the soldering iron. Heat the solder joint with the solder iron tip and pull the wire.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    William Jones

Member since: 09/04/2015

222 Reputation

                                      2 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       USF Tampa, Team 2-1, Sullivan Fall 2015                        

                                                  Member of USF Tampa, Team 2-1, Sullivan Fall 2015 



                    USFT-SULLIVAN-F15S2G1                     


                                            4 Members                     


                                            5 Guides authored