Vtech Kidizoom Smartwatch Dx2 Camera Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          7 minutes

Sections

Master Switch
4 steps
Motherboard
3 steps
Camera
1 step

Flags

BackVTech Kidizoom Smartwatch DX2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Master Switch

Begin by flipping the watch over with its back facing upwards.

Begin by flipping the watch over with its back facing upwards.

1024

Step 2

Next, use the Phillips #00 screwdriver to unscrew the four 6.0 mm screws located in each corner of the watch to remove the backplate.

Next, use the Phillips #00 screwdriver to unscrew the four 6.0 mm screws located in each corner of the watch to remove the backplate.

Step 3

Gently lift the backplate up to remove it.

Gently lift the backplate up to remove it.

Step 4

After removing the backplate, lift the master switch up from the circuit board.

After removing the backplate, lift the master switch up from the circuit board.

Step 5

              Motherboard

Using a Phillips #00 screwdriver, remove the 0.6 mm screw.

Using a Phillips #00 screwdriver, remove the 0.6 mm screw.

Step 6

Carefully remove the speaker from the case without disconnecting it from the motherboard.

Carefully remove the speaker from the case without disconnecting it from the motherboard.

Step 7

Using the tweezers, carefully lift the bar holding the connection to the screen.
Remove the motherboard from the device.

Using the tweezers, carefully lift the bar holding the connection to the screen.

Remove the motherboard from the device.

Step 8

              Camera

Turn the motherboard so the battery is on the bottom and locate the two clips holding the cameras in place.
Carefully lift the clips and slide the cameras out.

Turn the motherboard so the battery is on the bottom and locate the two clips holding the cameras in place.

Carefully lift the clips and slide the cameras out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Nathaniel Cady

Member since: 10/26/2018

175 Reputation

                                      1 Guide authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       UMass Dartmouth, Team S3-G5, Peak Fall 2018                        

                                                  Member of UMass Dartmouth, Team S3-G5, Peak Fall 2018 



                    UMASSD-PEAK-F18S3G5                     


                                            4 Members                     


                                            7 Guides authored

Aaron Arora - Dec 12, 2020

to much and do not under stand it

Introduction#

What you need#

Team#

Introduction

What you need

Team