Vtech Kidizoom Smartwatch Dx2 Battery Replacement Repair Guide

Difficulty

Difficult

Steps

9

Time Required

                          15 - 30 minutes            

Sections

3

• Master Switch
• 4 steps
• Motherboard
• 3 steps
• Battery
• 2 steps

Flags

0

• BackVTech Kidizoom Smartwatch DX2

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Master Switch               

• Begin by flipping the watch over with its back facing upwards.

Begin by flipping the watch over with its back facing upwards.

1024

Step 2

• Next, use the Phillips #00 screwdriver to unscrew the four 6.0 mm screws located in each corner of the watch to remove the backplate.

Next, use the Phillips #00 screwdriver to unscrew the four 6.0 mm screws located in each corner of the watch to remove the backplate.

Step 3

• Gently lift the backplate up to remove it.

Gently lift the backplate up to remove it.

Step 4

• After removing the backplate, lift the master switch up from the circuit board.

After removing the backplate, lift the master switch up from the circuit board.

Step 5

              Motherboard               

• Using a Phillips #00 screwdriver, remove the 0.6 mm screw.

Using a Phillips #00 screwdriver, remove the 0.6 mm screw.

Step 6

• Carefully remove the speaker from the case without disconnecting it from the motherboard.

Carefully remove the speaker from the case without disconnecting it from the motherboard.

Step 7

• Using the tweezers, carefully lift the bar holding the connection to the screen.
• Remove the motherboard from the device.

Using the tweezers, carefully lift the bar holding the connection to the screen.

Remove the motherboard from the device.

Step 8

              Battery               

• Carefully pry the battery off of the circuit board using the plastic opening tool.

Carefully pry the battery off of the circuit board using the plastic opening tool.

Step 9

• De-solder the wires connecting the battery to the circuit board.
• Remove the battery.

De-solder the wires connecting the battery to the circuit board.

Remove the battery.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 

                    Jessica Richard                     

Member since: 10/25/2018

512 Reputation

                                      4 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       UMass Dartmouth, Team S3-G5, Peak Fall 2018                        

                                                  Member of UMass Dartmouth, Team S3-G5, Peak Fall 2018 



                    UMASSD-PEAK-F18S3G5                     


                                            4 Members                     


                                            7 Guides authored                     

Gabriel Baker - Apr 20, 2021

Reply

Hey guys, My VTech watch is plugged in but once I turn it on it does but then shows a dead battery. I actually didn’t play with it for a while and I left it dead battery.

So I might try this trick and see if it works.

Sometime i’ll try it

when I have the right tools