Difficulty
Easy
Steps
10
Time Required
10 minutes
Sections
2
- Back Panel
- 6 steps
- White Drum Head
- 4 steps
Flags
0
BackVtech Kidibeats Drum Set
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Locate the battery panel that is centered between the three leg supports at the bottom of the drum set.
Locate the battery panel that is centered between the three leg supports at the bottom of the drum set.
1024
Step 2
- To remove the battery panel, loosen the 10 mm panel screw using a flathead 4.0 screwdriver.
- You can also use a small coin to loosen the screw.
To remove the battery panel, loosen the 10 mm panel screw using a flathead 4.0 screwdriver.
You can also use a small coin to loosen the screw.
Step 3
- Using your fingers, pry open and remove the back battery panel.
Using your fingers, pry open and remove the back battery panel.
Step 4
- Use your fingers to remove each battery from its housing.
Use your fingers to remove each battery from its housing.
Step 5
- Using a Phillips #2 screwdriver, loosen and remove the six 14 mm screws.
Using a Phillips #2 screwdriver, loosen and remove the six 14 mm screws.
Step 6
- With your hands, separate the bottom panel from the drum set.
- When removing the bottom panel, be careful not to pull too hard in order to prevent damaging the connections from the motherboard to the speaker and power source.
With your hands, separate the bottom panel from the drum set.
When removing the bottom panel, be careful not to pull too hard in order to prevent damaging the connections from the motherboard to the speaker and power source.
Step 7
White Drum Head
- To replace the white drum head on the cymbal side, use a Phillips #00 screwdriver to loosen and remove the two 8 mm screws.
- To replace the white drum head on the side opposite of the cymbal, use a Phillips #00 screwdriver to loosen and remove the two 8 mm screws.
- The blue drums will fall after the screws are loosened. Be sure to brace the blue drums in this step in order to prevent damage to the connection points between the blue drum components and the motherboard.
To replace the white drum head on the cymbal side, use a Phillips #00 screwdriver to loosen and remove the two 8 mm screws.
To replace the white drum head on the side opposite of the cymbal, use a Phillips #00 screwdriver to loosen and remove the two 8 mm screws.
The blue drums will fall after the screws are loosened. Be sure to brace the blue drums in this step in order to prevent damage to the connection points between the blue drum components and the motherboard.
Step 8
- Loosen and remove the five 15 mm screws using a Phillips #2 screwdriver.
Loosen and remove the five 15 mm screws using a Phillips #2 screwdriver.
Step 9
- Using your hands, remove the orange rim and white drum head from the blue base.
Using your hands, remove the orange rim and white drum head from the blue base.
Step 10
- Using your hands, pull apart the white drum head from the orange rim.
Using your hands, pull apart the white drum head from the orange rim.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Aaron Klementowski
Member since: 02/09/2016
820 Reputation
6 Guides authored
Badges:
12
+9 more badges
Team
USF Tampa, Team 2-8, Cagle Spring 2016
Member of USF Tampa, Team 2-8, Cagle Spring 2016
USFT-CAGLE-S16S2G8
2 Members
6 Guides authored
