Difficulty
Moderate
Steps
4
Time Required
8 - 20 minutes
Sections
1
- Rear Panel
- 4 steps
Flags
0
BackVtech InnoTab 3S
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
The standard battery options for the InnoTab 3S is four AA batteries. Vtech also offers a rechargeable battery online. Both battery options are removed from the device in the same way.
What you need
Step 1
Rear Panel
- While holding the battery compartment locks down, slide the two battery doors outwards from the sides of the device.
- Remove the batteries from the device.
While holding the battery compartment locks down, slide the two battery doors outwards from the sides of the device.
Remove the batteries from the device.
1024
Step 2
- Remove six 7 mm screws from the interior of the battery compartment using a Phillips #1 screwdriver.
Remove six 7 mm screws from the interior of the battery compartment using a Phillips #1 screwdriver.
Step 3
- Using a nylon spudger, remove the five caps that hide the screws.
- Potential for device damage: Be careful not to scrape the plastic from the device using the spudger.
- When removing the caps, hold the spudger vertical to the board to make removal easier. Also try to push in with your spudger pointing towards the bottom of the device.
- Remove the five 5 mm Phillips #1 screws from the rear panel of the device.
Using a nylon spudger, remove the five caps that hide the screws.
Potential for device damage: Be careful not to scrape the plastic from the device using the spudger.
When removing the caps, hold the spudger vertical to the board to make removal easier. Also try to push in with your spudger pointing towards the bottom of the device.
Remove the five 5 mm Phillips #1 screws from the rear panel of the device.
Step 4
- Carefully remove the rear panel from the front panel of the device.
- Once the rear panel is removed, you’ll be able to see the motherboard and other components within the Vtech InnoTab 3s.
Carefully remove the rear panel from the front panel of the device.
Once the rear panel is removed, you’ll be able to see the motherboard and other components within the Vtech InnoTab 3s.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 5 other contributors
Karina Garcia
Member since: 08/30/2015
824 Reputation
6 Guides authored
Badges:
14
+11 more badges
Team
USF Tampa, Team 8-2, Eyestone Fall 2015
Member of USF Tampa, Team 8-2, Eyestone Fall 2015
USFT-EYESTONE-F15S8G2
4 Members
9 Guides authored