Vtech Innotab 2S Back Panel Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

Suggest a time??

Sections

Back Panel
5 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

BackVTech InnoTab 2s
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

What you need

Step 1

              Back Panel

Turn your device to where the back panel is facing you.

Turn your device to where the back panel is facing you.

1024

Step 2

Lift the Leg all the way up and twist the bottom to remove.
Once the bottom part pops out the whole leg should just come off.
Remove any game cartridge from the device.

Lift the Leg all the way up and twist the bottom to remove.

Once the bottom part pops out the whole leg should just come off.

Remove any game cartridge from the device.

Step 3

Remove all of the plastic tabs on the device. These are covering screws that will need to be removed.
These covers are made of hard plastic so they may be difficult to remove.
There is a special tab in the cartridge cover that is made of rubber, make sure to not break this tab.

Remove all of the plastic tabs on the device. These are covering screws that will need to be removed.

These covers are made of hard plastic so they may be difficult to remove.

There is a special tab in the cartridge cover that is made of rubber, make sure to not break this tab.

Step 4

Remove all nine screws from the back of the device using a J0 bit.
Remove the small battery.

Remove all nine screws from the back of the device using a J0 bit.

Remove the small battery.

Step 5

Using a plastic opening tool, detach the backplate from the front piece.
Do not use excessive force. Double check that you removed all the screws if the panel is not coming off easily.
Once the backplate has been removed, you will have access to the circuit board.

Using a plastic opening tool, detach the backplate from the front piece.

Do not use excessive force. Double check that you removed all the screws if the panel is not coming off easily.

Once the backplate has been removed, you will have access to the circuit board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors

                    Ricardo Espinosa

Member since: 10/06/2016

221 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       USF Tampa, Team 5-1, Lacy Fall 2016                        

                                                  Member of USF Tampa, Team 5-1, Lacy Fall 2016 



                    USFT-LACY-F16S5G1                     


                                            4 Members                     


                                            6 Guides authored

Better Introduction#

What you need#

Team#

Better Introduction

What you need

Team