Difficulty
Difficult
Steps
11
Time Required
15 minutes
Sections
3
- Battery
- 4 steps
- Circuit Board
- 3 steps
- Speaker
- 4 steps
Flags
1
Step Trimmer
This guide has unnecessary steps. Trim them to be more concise!
BackVTech CS6719-2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Push down on the battery cover in the direction of the arrow located on the back of the phone.
Push down on the battery cover in the direction of the arrow located on the back of the phone.
1024
Step 2
- Pull the battery cover off of the back of the phone.
Pull the battery cover off of the back of the phone.
Step 3
- Unplug the battery input cable.
Unplug the battery input cable.
Step 4
- Lift the battery out of the back of the phone.
Lift the battery out of the back of the phone.
Step 5
Circuit Board
- Remove the two 9mm screws on the back side with a Phillips #0 screwdriver.
Remove the two 9mm screws on the back side with a Phillips #0 screwdriver.
Step 6
- Use the plastic opening tool and spudger to pry the back side of the phone off.
Use the plastic opening tool and spudger to pry the back side of the phone off.
Step 7
- Remove the two 9mm screws located inside the back cover at the top.
Remove the two 9mm screws located inside the back cover at the top.
Step 8
Speaker
- Locate the metal shaped U clip holding the speaker on. Pull up and towards the top of the phone with the flat head tweezers.
- The clip is loose, it could fall out.
Locate the metal shaped U clip holding the speaker on. Pull up and towards the top of the phone with the flat head tweezers.
The clip is loose, it could fall out.
Step 9
- Lift speaker out.
Lift speaker out.
Step 10
- Heat up solder joint on the circuit board where the speaker wires are connected.
Heat up solder joint on the circuit board where the speaker wires are connected.
Step 11
- Refer to How To Solder and Desolder Connections How To Solder and Desolder Connections
- Note: Ensure the old solder joint is removed.
- Caution: Soldering iron and joint will become very ho
Refer to How To Solder and Desolder Connections How To Solder and Desolder Connections
Note: Ensure the old solder joint is removed.
Caution: Soldering iron and joint will become very ho
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 5 other contributors
Benjamin Field
Member since: 02/08/2016
270 Reputation
2 Guides authored
Badges:
9
+6 more badges
Team
IUPUI, Team 1-4, Baechle Spring 2016
Member of IUPUI, Team 1-4, Baechle Spring 2016
IUPUI-BAECHLE-S16S1G4
4 Members
16 Guides authored
stephenandrewjarvis - Jun 18, 2018
Reply
Where can I buy the speaker for the phone?
Al Diovanni - Feb 1, 2021
adafruit:
