Vtech Baby S Learning Laptop Mode Switch Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 - 10 minutes

Sections

Battery and Rear Panel
4 steps
Mode Switch
4 steps

Flags

BackVTech Baby’s Learning Laptop
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery and Rear Panel

To remove the battery door, loosen the screw shown using a Phillips #2 screwdriver.
A coin can also be used to loosen the screw.

To remove the battery door, loosen the screw shown using a Phillips #2 screwdriver.

A coin can also be used to loosen the screw.

1024

Step 2

Remove the battery door.
Take out the batteries.

Remove the battery door.

Take out the batteries.

Step 3

Remove the rear panel screws using a Phillips #2 screwdriver.
Two 21.6mm (Long)
One 9.8mm (Short)
Five 13.8mm (Medium)

Remove the rear panel screws using a Phillips #2 screwdriver.

Two 21.6mm (Long)

One 9.8mm (Short)

Five 13.8mm (Medium)

Step 4

Gently pull up on the rear panel.
Be careful not to pull on the wire connections.
Rest the laptop open on the table.

Gently pull up on the rear panel.

Be careful not to pull on the wire connections.

Rest the laptop open on the table.

Step 5

              Mode Switch

Using a Phillips #0 screwdriver, remove the three 7.3mm screws.

Using a Phillips #0 screwdriver, remove the three 7.3mm screws.

Step 6

Once the screws have been removed from the board, use a plastic opening tool to gently pry up the board and expose the mode switch assembly underneath.
Lay the board down gently and out of the way.
Take care not to damage any of the wires or the board itself.

Once the screws have been removed from the board, use a plastic opening tool to gently pry up the board and expose the mode switch assembly underneath.

Lay the board down gently and out of the way.

Take care not to damage any of the wires or the board itself.

Step 7

Using a Phillips #0 screwdriver, remove the seven screws securing the mode switch assembly to the device.
Five 7.3mm
Two 6.0mm

Using a Phillips #0 screwdriver, remove the seven screws securing the mode switch assembly to the device.

Five 7.3mm

Two 6.0mm

Step 8

Once the screws have been removed, the mode switch assembly can be removed easily.
Take care not to misplace the spring indicated in the picture.
You need this spring to find a matching replacement if it is in anyway damaged.

Once the screws have been removed, the mode switch assembly can be removed easily.

Take care not to misplace the spring indicated in the picture.

You need this spring to find a matching replacement if it is in anyway damaged.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Scott Parkinson

Member since: 09/09/2015

107 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       USF Tampa, Team 12-2, Blackwell Fall 2015                        

                                                  Member of USF Tampa, Team 12-2, Blackwell Fall 2015 



                    USFT-BLACKWELL-F15S12G2                     


                                            4 Members                     


                                            7 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team