Difficulty
Moderate
Steps
4
Time Required
Suggest a time??
Sections
1
- Battery and Rear Panel
- 4 steps
Flags
0
BackVTech Baby’s Learning Laptop
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery and Rear Panel
- To remove the battery door, loosen the screw shown using a Phillips #2 screwdriver.
- A coin can also be used to loosen the screw.
To remove the battery door, loosen the screw shown using a Phillips #2 screwdriver.
A coin can also be used to loosen the screw.
1024
Step 2
- Remove the battery door.
- Take out the batteries.
Remove the battery door.
Take out the batteries.
Step 3
- Remove the rear panel screws using a Phillips #2 screwdriver.
- Two 21.6mm (Long)
- One 9.8mm (Short)
- Five 13.8mm (Medium)
Remove the rear panel screws using a Phillips #2 screwdriver.
Two 21.6mm (Long)
One 9.8mm (Short)
Five 13.8mm (Medium)
Step 4
- Gently pull up on the rear panel.
- Be careful not to pull on the wire connections.
- Rest the laptop open on the table.
Gently pull up on the rear panel.
Be careful not to pull on the wire connections.
Rest the laptop open on the table.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 5 other contributors
Christopher Kourmoulakis
Member since: 09/03/2015
373 Reputation
3 Guides authored
Badges:
11
+8 more badges
Team
USF Tampa, Team 12-2, Blackwell Fall 2015
Member of USF Tampa, Team 12-2, Blackwell Fall 2015
USFT-BLACKWELL-F15S12G2
4 Members
7 Guides authored