Difficulty
Moderate
Steps
6
Time Required
20 minutes
Sections
1
- Power Button
- 6 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
BackVornado Duo
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Power Button
- Start off by using a Philips #2 screwdriver to remove all 8 10mm exterior screws on the rear of the device.
Start off by using a Philips #2 screwdriver to remove all 8 10mm exterior screws on the rear of the device.
1024
Step 2
- After screws have been removed, open fan up. Inside remove the black and silver directional fins.
After screws have been removed, open fan up. Inside remove the black and silver directional fins.
Step 3
- Remove the black 5mm screw inside of the fan blade cylinder.
Remove the black 5mm screw inside of the fan blade cylinder.
Step 4
- Find and locate the 10 mm screws on both sides of the circuit board enclosure. Remove both screws.
Find and locate the 10 mm screws on both sides of the circuit board enclosure. Remove both screws.
Step 5
- Take out the fan cylinder and the circuit board enclosure.
Take out the fan cylinder and the circuit board enclosure.
Step 6
- Look inside the frontal shell of the fan and locate power button.
- Remove by gently pulling button off notch and replace with new power button.
Look inside the frontal shell of the fan and locate power button.
Remove by gently pulling button off notch and replace with new power button.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 3 other contributors
Kyle Devoe
Member since: 09/28/2017
134 Reputation
1 Guide authored
Badges:
7
+4 more badges
Team
USF Tampa, Team S1-G1, Nance Fall 2017
Member of USF Tampa, Team S1-G1, Nance Fall 2017
USFT-NANCE-F17S1G1
3 Members
4 Guides authored
