Difficulty
Moderate
Steps
6
Time Required
9 - 10 minutes
Sections
1
- Circuit Board
- 6 steps
Flags
0
BackVornado Duo
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Circuit Board
- Start off by using a Philips #2 screwdriver to remove all 8 10mm exterior screws on the rear of the device.
Start off by using a Philips #2 screwdriver to remove all 8 10mm exterior screws on the rear of the device.
1024
Step 2
- Carefully take front panel off.
Carefully take front panel off.
Step 3
- Loosen 5 mm screw at bottom of fan blade located inside the blades.
Loosen 5 mm screw at bottom of fan blade located inside the blades.
Step 4
- Remove fan blade after unscrewing top 2 screws located on each side of the covered board.
Remove fan blade after unscrewing top 2 screws located on each side of the covered board.
Step 5
- Remove cover from board.
Remove cover from board.
Step 6
- Unsolder the circled spots on the mother board and resolder each wire to corresponding spot.
Unsolder the circled spots on the mother board and resolder each wire to corresponding spot.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 3 other contributors
Tyler Pettenger
Member since: 09/28/2017
536 Reputation
3 Guides authored
Badges:
13
+10 more badges
Team
USF Tampa, Team S1-G1, Nance Fall 2017
Member of USF Tampa, Team S1-G1, Nance Fall 2017
USFT-NANCE-F17S1G1
3 Members
4 Guides authored
