Difficulty
Easy
Steps
4
Time Required
Suggest a time??
Sections
2
- Vizio VTAB1008 Back Cover Removal
- 2 steps
- Wi-Fi Antenna
- 2 steps
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackVizio VTAB1008
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Vizio VTAB1008 Back Cover Removal
- Carefully slide the heavy duty opening tool between the gap on the side of the device with no buttons.
- Do not insert the opening tool too far into the tablet as this can damage connectors close to edges of the cover.
- The angled tip of the opening tool can be wedged into the device by pressing on the back of the opening tool with the thumb. Move the opening tool in a sliding motion to ensure all tabs separate.
- Corner tabs may require a more forceful prying tool. If needed, carefully insert the metal prying tool into corners to separate the tabs.
Carefully slide the heavy duty opening tool between the gap on the side of the device with no buttons.
Do not insert the opening tool too far into the tablet as this can damage connectors close to edges of the cover.
The angled tip of the opening tool can be wedged into the device by pressing on the back of the opening tool with the thumb. Move the opening tool in a sliding motion to ensure all tabs separate.
Corner tabs may require a more forceful prying tool. If needed, carefully insert the metal prying tool into corners to separate the tabs.
1024
Step 2
- Look into the tablet for loose connectors.
- There are three loose connectors: one for the screen, one for the digitizer, and one for the motherboard. They are held in place by the pressure of the backing and screen assemblies.
- Flip the backing from the button-less side over, being careful not to separate the ribbon connector from the display screen.
Look into the tablet for loose connectors.
There are three loose connectors: one for the screen, one for the digitizer, and one for the motherboard. They are held in place by the pressure of the backing and screen assemblies.
Flip the backing from the button-less side over, being careful not to separate the ribbon connector from the display screen.
Step 3
Wi-Fi Antenna
- Using the blue spudger/prying tool remove antenna connectors by prying them up from the motherboard.
Using the blue spudger/prying tool remove antenna connectors by prying them up from the motherboard.
Step 4
- Remove connectors from the back cover by gently prying.
- Connectors are glued down, but copper can be removed from the backing with light pulling.
Remove connectors from the back cover by gently prying.
Connectors are glued down, but copper can be removed from the backing with light pulling.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Gilberto Ambriz
Member since: 09/29/2016
546 Reputation
5 Guides authored
Badges:
12
+9 more badges
Team
Eastern Washington University, Team 1-1, Crane Fall 2016
Member of Eastern Washington University, Team 1-1, Crane Fall 2016
EWU-CRANE-F16S1G1
4 Members
12 Guides authored