Difficulty

Moderate

Steps

7

Time Required

                          20 minutes

Sections

2

  • Back Cover
  • 3 steps
  • Top Speaker + WIFI Antenna
  • 4 steps

Flags

0

  • BackVizio SmartCast Tablet Remote XR6P

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • Obtain the black plastic spudger tool from the iFixit toolkit. Position the device as shown in the picture. Insert the flat end of the spudger directly in the space above the power button between the back cover and front screen.

Obtain the black plastic spudger tool from the iFixit toolkit. Position the device as shown in the picture. Insert the flat end of the spudger directly in the space above the power button between the back cover and front screen.

1024

Step 2

  • Gently pry up on the plate with the spudger. You may hear some cracking noises as you work the spudger around your device, this is normal.

Gently pry up on the plate with the spudger. You may hear some cracking noises as you work the spudger around your device, this is normal.

Step 3

  • Pry around the edges of the tablet with your fingers until you have successfully removed the back of the device.

Pry around the edges of the tablet with your fingers until you have successfully removed the back of the device.

Step 4

              Top Speaker + WIFI Antenna
  • During this step, avoid pulling on the red and black wires as they can be easily damaged. Instead, grab only the plug itself.
  • Use the tweezers to grab the power plug connected to the red and black wires. Disconnect the plug by pulling the tweezers away from the device.

During this step, avoid pulling on the red and black wires as they can be easily damaged. Instead, grab only the plug itself.

Use the tweezers to grab the power plug connected to the red and black wires. Disconnect the plug by pulling the tweezers away from the device.

Step 5

  • Place the flat end of the black plastic spudger under the locking tab that holds the tail end of the black ribbon in place. Pry upwards unlocking the tail of the black ribbon. Use the tweezers to remove the black ribbon from the plug.

Place the flat end of the black plastic spudger under the locking tab that holds the tail end of the black ribbon in place. Pry upwards unlocking the tail of the black ribbon. Use the tweezers to remove the black ribbon from the plug.

Step 6

  • Remove the three 3mm screws holding the WIFI antennae in the device. Use the tweezers to grab and remove the metal plate securing the antennae.
  • Two of the screws are silver, while one is black.

Remove the three 3mm screws holding the WIFI antennae in the device. Use the tweezers to grab and remove the metal plate securing the antennae.

Two of the screws are silver, while one is black.

Step 7

  • Remove the WIFI antennae from the device and replace.

Remove the WIFI antennae from the device and replace.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Jordan Adams

Member since: 10/04/2018

445 Reputation

                                      4 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       Linn Benton Community College, Team S2-G5, Karnes Fall 2018                        

                                                  Member of Linn Benton Community College, Team S2-G5, Karnes Fall 2018 



                    LBCC-KARNES-F18S2G5                     


                                            3 Members                     


                                            12 Guides authored