Difficulty

Moderate

Steps

7

Time Required

                          30 minutes

Sections

2

  • Back Cover
  • 3 steps
  • Haptic Motor
  • 4 steps

Flags

0

  • BackVizio SmartCast Tablet Remote XR6P

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • Obtain the black plastic spudger tool from the iFixit toolkit. Position the device as shown in the picture. Insert the flat end of the spudger directly in the space above the power button between the back cover and front screen.

Obtain the black plastic spudger tool from the iFixit toolkit. Position the device as shown in the picture. Insert the flat end of the spudger directly in the space above the power button between the back cover and front screen.

1024

Step 2

  • Gently pry up on the plate with the spudger. You may hear some cracking noises as you work the spudger around your device, this is normal.

Gently pry up on the plate with the spudger. You may hear some cracking noises as you work the spudger around your device, this is normal.

Step 3

  • Pry around the edges of the tablet with your fingers until you have successfully removed the back of the device.

Pry around the edges of the tablet with your fingers until you have successfully removed the back of the device.

Step 4

              Haptic Motor
  • After removing the back cover, you will be able to gain access to the speaker component.

After removing the back cover, you will be able to gain access to the speaker component.

Step 5

  • Pry the speaker up gently with the pointy end of the metal spudger.

Pry the speaker up gently with the pointy end of the metal spudger.

Step 6

  • Pull the red and blue wires from the green circuit panel.

Pull the red and blue wires from the green circuit panel.

Step 7

  • When reassembling, you will need to use the soldering iron to solder the red and blue wires back to the circuit board.

When reassembling, you will need to use the soldering iron to solder the red and blue wires back to the circuit board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Shonna Dempsey

Member since: 10/03/2018

159 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       Linn Benton Community College, Team S2-G5, Karnes Fall 2018                        

                                                  Member of Linn Benton Community College, Team S2-G5, Karnes Fall 2018 



                    LBCC-KARNES-F18S2G5                     


                                            3 Members                     


                                            12 Guides authored