Difficulty
Moderate
Steps
11
Time Required
45 minutes
Sections
3
- Bottom Panel
- 3 steps
- Bass
- 2 steps
- Battery
- 6 steps
Flags
0
BackVizio SmartCast Crave 360
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Bottom Panel
- Orient the speaker so that the bottom faces up.
- Peel the rubber ring off of the bottom using the spudger.
Orient the speaker so that the bottom faces up.
Peel the rubber ring off of the bottom using the spudger.
1024
Step 2
- Remove the eight 5 mm screws connecting the bottom panel to the gray power port using a Phillips #000 screwdriver.
Remove the eight 5 mm screws connecting the bottom panel to the gray power port using a Phillips #000 screwdriver.
Step 3
- Lift the gray power port and move it to the side to reveal the bass.
- Do not touch the wire that runs from the power port to the bottom of the bass component.
Lift the gray power port and move it to the side to reveal the bass.
Do not touch the wire that runs from the power port to the bottom of the bass component.
Step 4
Bass
- Remove the collar that wraps around the bass component.
- Once the collar is removed, the speaker should appear similar to the speaker shown in the second photo.
Remove the collar that wraps around the bass component.
Once the collar is removed, the speaker should appear similar to the speaker shown in the second photo.
Step 5
- Remove the four 10 mm screws with that connect the bass to the rest of the speaker using a Phillips #000 screwdriver.
- Take the bass component out of the speaker.
- Disconnect the wiring that runs into the bass component.
- The bass is now removed.
Remove the four 10 mm screws with that connect the bass to the rest of the speaker using a Phillips #000 screwdriver.
Take the bass component out of the speaker.
Disconnect the wiring that runs into the bass component.
The bass is now removed.
Step 6
Battery
- Flip the speaker to access the top.
- Remove the eight 10 mm screws from the plastic disc inside the grey speaker cage using a Phillips #000 screwdriver.
- Remove the plastic disc from the speaker cage.
Flip the speaker to access the top.
Remove the eight 10 mm screws from the plastic disc inside the grey speaker cage using a Phillips #000 screwdriver.
Remove the plastic disc from the speaker cage.
Step 7
- Lift the grey speaker cage to reveal a black plastic cylinder that contains the battery.
Lift the grey speaker cage to reveal a black plastic cylinder that contains the battery.
Step 8
- Disconnect the wire that connects the motherboard to the battery.
Disconnect the wire that connects the motherboard to the battery.
Step 9
- Remove the motherboard and battery from the plastic cylinder.
Remove the motherboard and battery from the plastic cylinder.
Step 10
- Remove the four 5 mm screws from the motherboard using a Phillips #000 screwdriver.
Remove the four 5 mm screws from the motherboard using a Phillips #000 screwdriver.
Step 11
- Remove the motherboard from the battery.
Remove the motherboard from the battery.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Pavani Lopez Leon
Member since: 09/06/2022
415 Reputation
3 Guides authored
Badges:
8
+5 more badges
Team
University of Colorado Denver, Team 1-4, Campeau Fall 2022
Member of University of Colorado Denver, Team 1-4, Campeau Fall 2022
UCDENVER-CAMPEAU-F22S1G4
4 Members
3 Guides authored
