Difficulty
Easy
Steps
5
Time Required
10 - 15 minutes
Sections
2
- Back Panel
- 2 steps
- Front-Facing Camera
- 3 steps
Flags
0
BackVisual Land Prestige Pro 7D
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Unscrew the two 4.0mm Phillips head screws found near the ports at the bottom of the device using a PH #00 screwdriver.
Unscrew the two 4.0mm Phillips head screws found near the ports at the bottom of the device using a PH #00 screwdriver.
1024
Step 2
- Be careful when taking the back panel off. The speaker is connected to both the front and back panels, and may get pulled out if you are not gentle when lifting the back panel away.
- Slide the plastic prying tool in between the front and back panel and pry them apart on all 4 sides.
- It may be easiest to start on one of the sides, and work your way around the device. The bottom, with the ports, is the most difficult side and can be saved for last.
- There are small latches that make this difficult. Moderate force may be required to separate the two panels.
Be careful when taking the back panel off. The speaker is connected to both the front and back panels, and may get pulled out if you are not gentle when lifting the back panel away.
Slide the plastic prying tool in between the front and back panel and pry them apart on all 4 sides.
It may be easiest to start on one of the sides, and work your way around the device. The bottom, with the ports, is the most difficult side and can be saved for last.
There are small latches that make this difficult. Moderate force may be required to separate the two panels.
Step 3
Front-Facing Camera
- Remove the black pad on the back of the camera by peeling it off.
Remove the black pad on the back of the camera by peeling it off.
Step 4
- With the bottom of the device facing away from you, pull the camera out of its black housing.
- The camera will come right out when you lift with your fingers.
With the bottom of the device facing away from you, pull the camera out of its black housing.
The camera will come right out when you lift with your fingers.
Step 5
- Use the tweezers to lift the grey connector, connecting the camera ribbon to the circuit board, up from the beige housing. It should rotate up, and allow you to slide the ribbon out from under the connector.
Use the tweezers to lift the grey connector, connecting the camera ribbon to the circuit board, up from the beige housing. It should rotate up, and allow you to slide the ribbon out from under the connector.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Brandon Kodama
Member since: 10/17/2014
229 Reputation
1 Guide authored
Badges:
7
+4 more badges
Team
Cal Poly, Team 10-41, Amido Fall 2014
Member of Cal Poly, Team 10-41, Amido Fall 2014
CPSU-AMIDO-F14S10G41
4 Members
12 Guides authored