Visioneer Onetouch 7400 Usb Outer Case Replacement Repair Guide

Difficulty

Moderate

Steps

4

Time Required

                          20 - 30 minutes            

Sections

1

• Outer Case
• 4 steps

Flags

2

Incorrect Tools

Help make this guide better by using the correct tools in images and/or text.

Better Introduction

Improve this guide by completing or revising its introduction.

• BackVisioneer OneTouch 7400 USB

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Outer Case               

• On the bottom of the scanner, remove the screw at the top left side.

On the bottom of the scanner, remove the screw at the top left side.

1024

Step 2

• Remove the rubber foot pad opposite the screw hole to expose a second screw hole.
• Remove the screw beneath the foot-pad.

Remove the rubber foot pad opposite the screw hole to expose a second screw hole.

Remove the screw beneath the foot-pad.

Step 3

• Rotate the scanner so the screw hole is located on the top left hand side.
• Place the plastic opening tool between the top casement and bottom casement of scanner with the hook facing up.
• Gently pry the two casements apart beginning above the screw hole and working your way around.
• Note that the top and bottom casings are held together by a series of 6 tabs. There is one tab on each of the long sides of the scanner approximately 6 inches in from the corners. There are two tabs on each of the short sides of the scanner approximately 2.3 inches in from the corners. Use the spudger to unhook the tab from the top casement.

Rotate the scanner so the screw hole is located on the top left hand side.

Place the plastic opening tool between the top casement and bottom casement of scanner with the hook facing up.

Gently pry the two casements apart beginning above the screw hole and working your way around.

Note that the top and bottom casings are held together by a series of 6 tabs. There is one tab on each of the long sides of the scanner approximately 6 inches in from the corners. There are two tabs on each of the short sides of the scanner approximately 2.3 inches in from the corners. Use the spudger to unhook the tab from the top casement.

Step 4

• Separate the two casement pieces.

Separate the two casement pieces.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 5 other contributors 

                    Jena                     

Member since: 10/18/2013

608 Reputation

                                      6 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       University of Maine, Team 1-13, Diaz Fall 2013                        

                                                  Member of University of Maine, Team 1-13, Diaz Fall 2013 



                    UMAINE-DIAZ-F13S1G13                     


                                            3 Members                     


                                            8 Guides authored