Difficulty
Easy
Steps
6
Time Required
5 minutes
Sections
1
- Viasys Avea UIM and Plastic Cover Disassembly
- 6 steps
Flags
0
BackViasys Avea Ventilator
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Removing the UIM and plastic cover is discussed in service manual revision D:
- Chapter 4: Assembly and Disassembly, Pg 50-51
PLEASE NOTE: This repair guide was developed by a student iFixit team based on Viasys/CareFusion’s own service manual. Neither iFixit nor this repair guide is endorsed by or affiliated with Viasys or CareFusion.
What you need
Step 1
Viasys Avea UIM and Plastic Cover Disassembly
- Remove the ‘rubber collar’ located at the UIM rear neck, by grasping one of the two rubber tabs at the bottom. Pull firmly in an “arcing” motion.
Remove the ‘rubber collar’ located at the UIM rear neck, by grasping one of the two rubber tabs at the bottom. Pull firmly in an “arcing” motion.
1024
Step 2
- Pull UIM forward and look for the Phillips Screw on the front arm cover. Remove (1) Phillips screw from the front arm cover. Remove the front arm cover.
Pull UIM forward and look for the Phillips Screw on the front arm cover. Remove (1) Phillips screw from the front arm cover. Remove the front arm cover.
Step 3
- Remove the two mounting screws now visible inside the ‘back arm cover’. Tilt the UIM down and remove the ‘back arm cover’.
Remove the two mounting screws now visible inside the ‘back arm cover’. Tilt the UIM down and remove the ‘back arm cover’.
Step 4
- Remove the (4) 11/32 KEP nuts that secure the ‘plastic top cover’ opening onto the chassis.
- Remove (2) Phillips screws that secure the ‘plastic top cover’ to the rear chassis.
- Slide the top ‘plastic top cover’ upward and forward away from the chassis.
Remove the (4) 11/32 KEP nuts that secure the ‘plastic top cover’ opening onto the chassis.
Remove (2) Phillips screws that secure the ‘plastic top cover’ to the rear chassis.
Slide the top ‘plastic top cover’ upward and forward away from the chassis.
Step 5
- Remove the (2) Phillips screws and washers that secure the HSSC Cable on the GDE. Unplug the HSSC Cable.
- Carefully feed the HSSC Cable through the ‘plastic top cover’ opening.
Remove the (2) Phillips screws and washers that secure the HSSC Cable on the GDE. Unplug the HSSC Cable.
Carefully feed the HSSC Cable through the ‘plastic top cover’ opening.
Step 6
- While continuously supporting the UIM, remove (4) 3/8 nuts that fasten the UIM support arm onto the pneumatics.
- Lift UIM off of pneumatics and set aside.
- Remove plastic cover and set aside.
While continuously supporting the UIM, remove (4) 3/8 nuts that fasten the UIM support arm onto the pneumatics.
Lift UIM off of pneumatics and set aside.
Remove plastic cover and set aside.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Anthony Hernandez
Member since: 05/04/2020
394 Reputation
3 Guides authored
Badges:
5
+2 more badges
Team
Cal Poly, Team S1-G1, Zimmerman Spring 2020
Member of Cal Poly, Team S1-G1, Zimmerman Spring 2020
CPSU-ZIMMERMAN-S20S1G1
5 Members
6 Guides authored