Verizon M1424Wr Motherboard Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          10 minutes            

Sections

1

• Motherboard
• 7 steps

Flags

0

• BackVerizon M1424WR

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

This router will have to be reauthenitcated with Verizon if you replace any WAN hardware or the whole board. Your new MAC address will not be approved.

What you need

Step 1

              Motherboard               

• Flip the device so that the bottom is facing up.

Flip the device so that the bottom is facing up.

1024

Step 2

• Insert the plastic-opening tool under the silver labeled casing.
• Carefully pry at different intervals around the silver labeled casing to separate the silver casing from the top and bottom casing.

Insert the plastic-opening tool under the silver labeled casing.

Carefully pry at different intervals around the silver labeled casing to separate the silver casing from the top and bottom casing.

Step 3

• Unscrew the five 10-mm screws on the bottom of the router using a Phillips #0 screwdriver.

Unscrew the five 10-mm screws on the bottom of the router using a Phillips #0 screwdriver.

Step 4

• Use a plastic-opening tool and pry the top casing from the bottom casing to expose the circuit board in the bottom half of the device.

Use a plastic-opening tool and pry the top casing from the bottom casing to expose the circuit board in the bottom half of the device.

Step 5

• Locate the two 10-mm screws on either side of the circuit board.
• Unscrew the two 10-mm screws using a Phillips #0 screwdriver.
• Keep track of the red rubber washer you remove from underneath one of the screws.

Locate the two 10-mm screws on either side of the circuit board.

Unscrew the two 10-mm screws using a Phillips #0 screwdriver.

Keep track of the red rubber washer you remove from underneath one of the screws.

Step 6

• Lift the front of the circuit board up from the bottom casing.

Lift the front of the circuit board up from the bottom casing.

Step 7

• Pull the circuit board towards you until it is separate from the bottom casing.

Pull the circuit board towards you until it is separate from the bottom casing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 3 other contributors 

                    Jeffrey Fox                     

Member since: 09/17/2014

347 Reputation

                                      3 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       University of Kentucky Louisville, Team 1-3, Mathis Fall 2014                        

                                                  Member of University of Kentucky Louisville, Team 1-3, Mathis Fall 2014 



                    LOUISVILLE-MATHIS-F14S1G3                     


                                            3 Members                     


                                            4 Guides authored