Difficulty
Easy
Steps
4
Time Required
4 - 5 minutes
Sections
2
- Front Screen
- 2 steps
- Power Cord
- 2 steps
Flags
0
BackVenturer CR20
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Front Screen
- On the bottom of the clock locate and unscrew the single 2mm Phillips screw from bottom of the clock.
On the bottom of the clock locate and unscrew the single 2mm Phillips screw from bottom of the clock.
1024
Step 2
- Using a moderate amount of force, position the screwdriver in the crack between the front screen and the main body of the clock (as shown) and push the screen away from the main body of the clock.
Using a moderate amount of force, position the screwdriver in the crack between the front screen and the main body of the clock (as shown) and push the screen away from the main body of the clock.
Step 3
Power Cord
- Get a firm grip on the outside of the clock and a firm grip on the hardware on the inside of the the clock like so and pull the hardware out from the outside of the clock.
Get a firm grip on the outside of the clock and a firm grip on the hardware on the inside of the the clock like so and pull the hardware out from the outside of the clock.
Step 4
- Using your fingers, pull the power cord connector, outlined in the picture with a red rectangle straight up to disconnect from the alarm clock.
Using your fingers, pull the power cord connector, outlined in the picture with a red rectangle straight up to disconnect from the alarm clock.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 5 other contributors
Robert Myers
Member since: 01/11/2013
54 Reputation
5 Guides authored
Badges:
6
+3 more badges
Team
Cal Poly, Team 5-15, Forte Winter 2013
Member of Cal Poly, Team 5-15, Forte Winter 2013
CPSU-FORTE-W13S5G15
5 Members
5 Guides authored