Difficulty

Easy

Steps

7

Time Required

                          20 minutes

Sections

1

  • Brush Roll
  • 7 steps

Flags

0

  • BackBissell Vacuum

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Brush Roll
  • Lay the vacuum flat on the ground, then use a sturdy object to prop up the bottom.

Lay the vacuum flat on the ground, then use a sturdy object to prop up the bottom.

1024

Step 2

  • Use a Phillips #0 screwdriver to remove the eight screws securing the brush housing.

Use a Phillips #0 screwdriver to remove the eight screws securing the brush housing.

Step 3

  • Gently pull at each corner of the brush housing until it releases from the chassis.
  • Remove the brush housing.

Gently pull at each corner of the brush housing until it releases from the chassis.

Remove the brush housing.

Step 4

  • Unlatch the two white plastic hooks securing the brush.

Unlatch the two white plastic hooks securing the brush.

Step 5

  • Lift the brush up and out of its housing.
  • Keep and reuse the black rubber belt if it’s not damaged.

Lift the brush up and out of its housing.

Keep and reuse the black rubber belt if it’s not damaged.

Step 6

  • Loop the black rubber belt around the notched wheel on the right side of the brush, then place the brush roll back in its housing and lock the white plastic latch.
  • Lock the white plastic latch on the left side of the brush.

Loop the black rubber belt around the notched wheel on the right side of the brush, then place the brush roll back in its housing and lock the white plastic latch.

Lock the white plastic latch on the left side of the brush.

Step 7

  • Before replacing the top of the brush housing, make sure the black rubber belt is secured around the black notched wheel on the right side of the brush, as well as the notched wheel on the motor.

Before replacing the top of the brush housing, make sure the black rubber belt is secured around the black notched wheel on the right side of the brush, as well as the notched wheel on the motor.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Faizan Shaikh

Member since: 01/17/2022

145 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       York University, Team P-27, O'Regan Winter 2022                        

                                                  Member of York University, Team P-27, O'Regan Winter 2022 



                    YORK-O'REGAN-W22SPG27                     


                                            1 Member                     


                                            1 Guide authored