Difficulty
Moderate
Steps
10
Time Required
15 - 25 minutes
Sections
1
- Speaker Woofer
- 10 steps
Flags
0
BackUrge Basics Soundbrick
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Speaker Woofer
- Flip the speaker upside down.
- Unscrew the middle screw with a Philips #1 screwdriver.
Flip the speaker upside down.
Unscrew the middle screw with a Philips #1 screwdriver.
1024
Step 2
- Peel off the two gray tabs to expose the four inner Philips #1 screws.
Peel off the two gray tabs to expose the four inner Philips #1 screws.
Step 3
- Unscrew all four screws with a Philips #1 screwdriver.
- The screws are deep and can be difficult to take out.
Unscrew all four screws with a Philips #1 screwdriver.
The screws are deep and can be difficult to take out.
Step 4
- Flip the speaker so that the ports are facing up.
- Unfold the speaker’s cover away from the body.
Flip the speaker so that the ports are facing up.
Unfold the speaker’s cover away from the body.
Step 5
- Remove the two Phillips #1 screws found on each side of the battery compartment.
- Removal of battery compartment is necessary to prevent electric shock when replacing the woofer.
Remove the two Phillips #1 screws found on each side of the battery compartment.
Removal of battery compartment is necessary to prevent electric shock when replacing the woofer.
Step 6
- Disconnect the battery connectors attached to the circuit board by unplugging them.
Disconnect the battery connectors attached to the circuit board by unplugging them.
Step 7
- Disconnect the ribbon cable from the battery by carefully pulling it out.
- Remove the battery compartment.
Disconnect the ribbon cable from the battery by carefully pulling it out.
Remove the battery compartment.
Step 8
- Disconnect the adjacent connector from the main circuit board.
Disconnect the adjacent connector from the main circuit board.
Step 9
- Disconnect the woofer’s two connectors from the main circuit board.
Disconnect the woofer’s two connectors from the main circuit board.
Step 10
- Remove the two Phillips #1 screws keeping each woofer in place.
- Carefully remove the woofers and replace them with new ones.
Remove the two Phillips #1 screws keeping each woofer in place.
Carefully remove the woofers and replace them with new ones.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Itzel Urueta
Member since: 04/28/2017
125 Reputation
1 Guide authored
Badges:
4
+1 more badge
Team
UC Davis, Team S2-G4, Cole Spring 2017
Member of UC Davis, Team S2-G4, Cole Spring 2017
UCD-COLE-S17S2G4
3 Members
1 Guide authored