Difficulty
Difficult
Steps
11
Time Required
10 - 30 minutes
Sections
2
- Unnecto Drone M Disassembly
- 8 steps
- Headphone Jack
- 3 steps
Flags
4
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
Confusing Text
Some of this guide’s text is confusing, duplicated, or off-topic. Clarify it by editing!
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
Better Introduction
Improve this guide by completing or revising its introduction.
BackUnnecto Drone M
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Unnecto Drone M Disassembly
- Place the phone facedown on a cleared work area
- Remove the back case by applying moderate force to the indentation in the lower left corner of the case.
Place the phone facedown on a cleared work area
Remove the back case by applying moderate force to the indentation in the lower left corner of the case.
1024
Step 2
- Grip the top right corner of the battery.
- Remove the battery by pulling it outwards.
Grip the top right corner of the battery.
Remove the battery by pulling it outwards.
Step 3
- Remove the four screws on the back of the phone using a Philips 000 screwdriver
Remove the four screws on the back of the phone using a Philips 000 screwdriver
Step 4
- Separate the frame evenly using a plastic opening tool.
- Be careful, as the frame is thin and can break easily.
Separate the frame evenly using a plastic opening tool.
Be careful, as the frame is thin and can break easily.
Step 5
- Use a Phillips #000 screwdriver to remove the four screws that secure the motherboard.
Use a Phillips #000 screwdriver to remove the four screws that secure the motherboard.
Step 6
- Disconnect the ribbon cable from the motherboard using rounded, spade-tipped tweezers.
Disconnect the ribbon cable from the motherboard using rounded, spade-tipped tweezers.
Step 7
- Peel the white circuit on left side of the frame by inserting fine-tipped tweezers between it and the frame.
- The white circuit is flimsy and securely glued to the frame.
Peel the white circuit on left side of the frame by inserting fine-tipped tweezers between it and the frame.
The white circuit is flimsy and securely glued to the frame.
Step 8
- Set aside the circuit board from the screen protector.
Set aside the circuit board from the screen protector.
Step 9
Headphone Jack
- Desolder the headphone jack using a soldering iron on each of the 6 points holding it down.
- Be careful to not damage the circuit board.
Desolder the headphone jack using a soldering iron on each of the 6 points holding it down.
Be careful to not damage the circuit board.
Step 10
- Solder on a new headphone jack.
Solder on a new headphone jack.
Step 11
- Make sure the new jack is aligned properly and securely soldered to the circuit board.
Make sure the new jack is aligned properly and securely soldered to the circuit board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
John Stavrianopoulos
Member since: 02/08/2018
175 Reputation
2 Guides authored
Badges:
4
+1 more badge
Team
University of North Texas, Team S6-G4, Thomas Spring 2018
Member of University of North Texas, Team S6-G4, Thomas Spring 2018
UNT-THOMAS-S18S6G4
4 Members
10 Guides authored