Difficulty
Moderate
Steps
9
Time Required
5 minutes
Sections
3
- Battery
- 3 steps
- Keyboard
- 3 steps
- Display
- 3 steps
Flags
0
BackUniden D1760-2 DECT 6.0
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Make sure the screen isn’t faulty due to the battery before moving on. Check the Uniden Dect 6.0 Troubleshooting page for more information.
What you need
Step 1
Battery
- Locate the battery compartment on the back of the Uniden home phone.
- Place your finger on the groove, and pull directly back on the cover to access to the battery.
Locate the battery compartment on the back of the Uniden home phone.
Place your finger on the groove, and pull directly back on the cover to access to the battery.
1024
Step 2
- Remove the white battery pack from the battery compartment.
Remove the white battery pack from the battery compartment.
Step 3
- Remove the red-and-black-wired port from the plug directly under the battery compartment.
Remove the red-and-black-wired port from the plug directly under the battery compartment.
Step 4
Keyboard
- Using a Phillips #1 screwdriver, remove the two .9 mm screws on the back of the device on each side of the battery pack.
Using a Phillips #1 screwdriver, remove the two .9 mm screws on the back of the device on each side of the battery pack.
Step 5
- Using your fingers, gently lift and separate the front of the housing from the back housing.
- Potential for device damage: While separating the back housing from the front, be sure to open from the sides as pictured.
Using your fingers, gently lift and separate the front of the housing from the back housing.
Potential for device damage: While separating the back housing from the front, be sure to open from the sides as pictured.
Step 6
- Gently remove the loose keyboard from the lined gel casing located under the front housing of the front of the phone.
Gently remove the loose keyboard from the lined gel casing located under the front housing of the front of the phone.
Step 7
Gel Casing
- To better access the screen, remove the loose gel casing that sits under the keyboard.
To better access the screen, remove the loose gel casing that sits under the keyboard.
Step 8
- Lift out the attached motherboard piece and turn it sideways to access the side of the phone.
- Potential for device damage: Use caution to avoid severing the wires that connect the motherboard to the phone.
Lift out the attached motherboard piece and turn it sideways to access the side of the phone.
Potential for device damage: Use caution to avoid severing the wires that connect the motherboard to the phone.
Step 9
- Gently use the tweezers to access the motherboard panel and lift it straight up.
Gently use the tweezers to access the motherboard panel and lift it straight up.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 7 other contributors
Megan Lawrence
Member since: 01/14/2015
534 Reputation
5 Guides authored
Badges:
8
+5 more badges
Team
USF Sarasota-Manatee, Team 1-3, Stewart Winter 2015
Member of USF Sarasota-Manatee, Team 1-3, Stewart Winter 2015
USFSM-STEWART-W15S1G3
4 Members
11 Guides authored
