Difficulty
Moderate
Steps
8
Time Required
10 - 20 minutes
Sections
3
- Battery
- 3 steps
- Handset Case
- 4 steps
- Handset Keypad
- 1 step
Flags
1
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
BackUniden D1483-3BK
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Set the phone with dial keys facing downward.
Set the phone with dial keys facing downward.
1024
Step 2
- Slide the battery cover toward the bottom of the phone.
- Lift and remove the back cover from the phone.
Slide the battery cover toward the bottom of the phone.
Lift and remove the back cover from the phone.
Step 3
- Remove the battery from its compartment.
- Pinch the end of cord where the battery is attached to the phone and pull up gently.
Remove the battery from its compartment.
Pinch the end of cord where the battery is attached to the phone and pull up gently.
Step 4
Handset Case
- Remove the two 9mm Phillips #1 screws in the battery compartment.
Remove the two 9mm Phillips #1 screws in the battery compartment.
Step 5
- Use the plastic opening tool to carefully separate the two halves of the case.
- Slowly work around the entire case to fully separate the halves before pulling them apart.
- Wires inside the case hold the two halves together, tearing these wires will lead to a need for additional repair.
Use the plastic opening tool to carefully separate the two halves of the case.
Slowly work around the entire case to fully separate the halves before pulling them apart.
Wires inside the case hold the two halves together, tearing these wires will lead to a need for additional repair.
Step 6
- Carefully remove the 9mm Phillips #1 screw from the top corner of the circuit board.
Carefully remove the 9mm Phillips #1 screw from the top corner of the circuit board.
Step 7
- Carefully grasp either side of the circuit board and lift it straight out of the front half of the case.
- Set the board in the lower half of the case.
Carefully grasp either side of the circuit board and lift it straight out of the front half of the case.
Set the board in the lower half of the case.
Step 8
Handset Keypad
- Remove the rubber keypad from the front half of the handset case.
- The keypad comes in two separate pieces.
Remove the rubber keypad from the front half of the handset case.
The keypad comes in two separate pieces.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
6 other people completed this guide.
Author
with 1 other contributor
Arbitrary Name
Member since: 01/28/2015
1,083 Reputation
4 Guides authored
Badges:
18
+15 more badges
Team
Penn State, Team 1-8, Kaschak Winter 2015
Member of Penn State, Team 1-8, Kaschak Winter 2015
PSU-KASCHAK-W15S1G8
4 Members
8 Guides authored