Difficulty
Easy
Steps
11
Time Required
1 hour
Sections
1
- Motherboard
- 11 steps
Flags
2
Bullets!
Better coordination with markups and the color/type of bullets will help make this guide more clear!
Slice and Dice
The steps in this guide should be split up and made into a series of prerequisite guides.
BackUnbranded UB-15MS10
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Motherboard
- Use an opening tool to pry off the memory card door located on the back of the tablet.
Use an opening tool to pry off the memory card door located on the back of the tablet.
1024
Step 2
- Remove the two 1.2mm screws found under the memory card door.
Remove the two 1.2mm screws found under the memory card door.
Step 3
- Pry around the outside carefully using the black spudger to get in. Putting many opening tools around the edge helps keep it from sealing shut again.
Pry around the outside carefully using the black spudger to get in. Putting many opening tools around the edge helps keep it from sealing shut again.
Step 4
- Remove the ribbon cable by using the black spudger to release the tab and carefully pull out the ribbon cable.
Remove the ribbon cable by using the black spudger to release the tab and carefully pull out the ribbon cable.
Step 5
- Peel up the grey tape so that you can get to the board and untape the ribbon cable that was removed from the motherboard in the previous step.
Peel up the grey tape so that you can get to the board and untape the ribbon cable that was removed from the motherboard in the previous step.
Step 6
- Remove the five 1.2mm screws from the board.
Remove the five 1.2mm screws from the board.
Step 7
- Use an opening tool to remove the board from the case.
Use an opening tool to remove the board from the case.
Step 8
- Detach the three ribbon cables using spudger in the first picture. Then cut the black, white, and red wires shown in picture two.
Detach the three ribbon cables using spudger in the first picture. Then cut the black, white, and red wires shown in picture two.
Step 9
- Unscrew the two 1.2mm screws of this component, which is wired to the motherboard.
Unscrew the two 1.2mm screws of this component, which is wired to the motherboard.
Step 10
- Unscrew the two 1.2mm screws of this component, which is also wired to the motherboard.
Unscrew the two 1.2mm screws of this component, which is also wired to the motherboard.
Step 11
- Remove old motherboard from tablet. Take the new motherboard and splice the black wire of the board to the black wire of the battery. Do the same for the white and red wires.
Remove old motherboard from tablet. Take the new motherboard and splice the black wire of the board to the black wire of the battery. Do the same for the white and red wires.
To reassemble your device, follow steps 1-10 in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Matthew Sylvia
Member since: 03/08/2017
280 Reputation
2 Guides authored
Badges:
8
+5 more badges
Team
UMass Dartmouth, Team S5-G5, Botvin Spring 2017
Member of UMass Dartmouth, Team S5-G5, Botvin Spring 2017
UMASSD-BOTVIN-S17S5G5
3 Members
4 Guides authored
Ayo Olowo - Feb 19, 2018
Reply
Please where can I get the motherboard or charging IC of UB15MS10