Difficulty
Moderate
Steps
5
Time Required
10 - 15 minutes
Sections
1
- Camera
- 5 steps
Flags
0
BackUdi Discovery U818A FPV
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Camera
- Place the drone on its back, with the runners facing upward.
- Using the Phillips #00 screwdriver, unscrew the single 2mm screw located on the drone body which connects the headlamp and wiring to the center of the drone frame.
Place the drone on its back, with the runners facing upward.
Using the Phillips #00 screwdriver, unscrew the single 2mm screw located on the drone body which connects the headlamp and wiring to the center of the drone frame.
1024
Step 2
- Grasp one of the propeller arms with the fingers of one hand while holding the drone frame with the other hand.
- Firmly pull the propeller arm upward to separate it from the drone body.
- Repeat this process to remove the three other propeller arms.
Grasp one of the propeller arms with the fingers of one hand while holding the drone frame with the other hand.
Firmly pull the propeller arm upward to separate it from the drone body.
Repeat this process to remove the three other propeller arms.
Step 3
- Carefully remove the drone body from the frame.
Carefully remove the drone body from the frame.
Step 4
- Flip the drone body onto the runners so the wires and motherboard are facing upward.
- Disconnect the black and blue camera wires from the motherboard.
- You may need to use a pointed metal pick to loosen the red putty that holds the connectors together.
Flip the drone body onto the runners so the wires and motherboard are facing upward.
Disconnect the black and blue camera wires from the motherboard.
You may need to use a pointed metal pick to loosen the red putty that holds the connectors together.
Step 5
- Be careful when separating the camera away from the runners and drone body—the plastic is brittle and may snap, causing injury to the hand.
- Pry the camera away from the main drone body.
- Use a spudger for extra leverage if the parts do not easily separate.
Be careful when separating the camera away from the runners and drone body—the plastic is brittle and may snap, causing injury to the hand.
Pry the camera away from the main drone body.
Use a spudger for extra leverage if the parts do not easily separate.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Debra Crawford
Member since: 10/11/2018
401 Reputation
3 Guides authored
Badges:
8
+5 more badges
Team
Eastern Washington University, Team S4-G2, Crane Fall 2018
Member of Eastern Washington University, Team S4-G2, Crane Fall 2018
EWU-CRANE-F18S4G2
2 Members
4 Guides authored