Difficulty
Moderate
Steps
3
Time Required
20 minutes
Sections
2
- Ear Cushion
- 1 step
- Charging Contact Pins on Headset
- 2 steps
Flags
0
BackTurtle Beach Elite 800
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Ear Cushion
- To remove the ear cushions, press firmly down and rotate them clockwise, it should twist about 2mm and release, allowing you to pull it off.
- When reassembling, be sure to line up the locking plates.
To remove the ear cushions, press firmly down and rotate them clockwise, it should twist about 2mm and release, allowing you to pull it off.
When reassembling, be sure to line up the locking plates.
1024
Step 2
Charging Contact Pins on Headset
- Use the Phillips #0 screw bit to remove the four screws (9.47 mm long) that have been revealed from removing the ear cup. Carefully take off the blue casing to reveal the audio board.
Use the Phillips #0 screw bit to remove the four screws (9.47 mm long) that have been revealed from removing the ear cup. Carefully take off the blue casing to reveal the audio board.
Step 3
- Use the Phillips #00 screw bit to remove the two screws (7.92 mm long) that are holding the contact pins in place.
- Then, simply push the pins from the board.
Use the Phillips #00 screw bit to remove the two screws (7.92 mm long) that are holding the contact pins in place.
Then, simply push the pins from the board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Johnny Lofton
Member since: 01/18/2017
843 Reputation
5 Guides authored
Badges:
11
+8 more badges
Team
Arkansas State University, Team 1-5, Chamberlain Spring 2017
Member of Arkansas State University, Team 1-5, Chamberlain Spring 2017
ARSU-CHAMBERLAIN-S17S1G5
3 Members
10 Guides authored