Difficulty

Moderate

Steps

8

Time Required

Suggest a time??

Sections

2

  • Earpad Assembly
  • 2 steps
  • Battery
  • 6 steps

Flags

0

  • BackTurtle Beach Ear Force Stealth 500P

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Earpad Assembly
  • Remove the ear pad from the earphone by gently pulling the cloth pad outwards from the slot holding the cloth.
  • Work circularly until removed.

Remove the ear pad from the earphone by gently pulling the cloth pad outwards from the slot holding the cloth.

Work circularly until removed.

1024

Step 2

  • Using a Phillips #1 screwdriver, remove the four fastening screws that hold the blue plastic speaker mount in place.
  • Gently pull blue plastic from black housing by hand until separated.

Using a Phillips #1 screwdriver, remove the four fastening screws that hold the blue plastic speaker mount in place.

Gently pull blue plastic from black housing by hand until separated.

Step 3

              Battery
  • Use screwdriver tip J00 to remove three screws fastening circuit board to casing.

Use screwdriver tip J00 to remove three screws fastening circuit board to casing.

Step 4

  • Use bent tweezers to remove two wire connector plugs from circuit board.

Use bent tweezers to remove two wire connector plugs from circuit board.

Step 5

  • Circuit board will be free to be removed by hand. Use plastic pry tool to slide between casing and circuit board if needed.

Circuit board will be free to be removed by hand. Use plastic pry tool to slide between casing and circuit board if needed.

Step 6

  • Gently removed and flip over circuit board to reveal battery pack attached to the underside. Careful not to pull out wires running through headband.

Gently removed and flip over circuit board to reveal battery pack attached to the underside. Careful not to pull out wires running through headband.

Step 7

  • Use metal pry tool to slide between battery and circuit board to break up adhesive. Ensure the battery wire connector plug has been removed on front side.

Use metal pry tool to slide between battery and circuit board to break up adhesive. Ensure the battery wire connector plug has been removed on front side.

Step 8

  • Battery will be free to be removed and replaced.

Battery will be free to be removed and replaced.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      10 other people completed this guide.

Author

                                      with 5 other contributors 


                    Noah Franklin

Member since: 10/27/2015

445 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       UMass Dartmouth, Team 2-3, Shastany Fall 2015                        

                                                  Member of UMass Dartmouth, Team 2-3, Shastany Fall 2015 



                    UMASSD-SHASTANY-F15S2G3                     


                                            3 Members                     


                                            10 Guides authored

Jeremy Nocek - Aug 25, 2017

Reply

Where can I get a replacement battery?

William Smith - Nov 24, 2017

Reply

The costs are like $20-$30.

If you look on Ebay under: ( 3.7v 603048 ), you can get the same battery without the connector for like $5.

fiercecesar - Nov 29, 2018

Reply

hey i have a question, how i can repair the mute button? It does not work.