Difficulty
Moderate
Steps
8
Time Required
Suggest a time??
Sections
4
- Outside Casing
- 2 steps
- Keyboard
- 1 step
- Motherboard
- 2 steps
- Power Cord
- 3 steps
Flags
0
BackTRS-80 Color Computer
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Outside Casing
- Flip the computer over.
- Remove the two 24.1mm Phillips screws near the front of the case.
- Remove the five 33.0 mm Phillips screws towards the back of the case.
Flip the computer over.
Remove the two 24.1mm Phillips screws near the front of the case.
Remove the five 33.0 mm Phillips screws towards the back of the case.
1024
Step 2
- Carefully flip the computer right side up.
- Lift off the top half of the case.
Carefully flip the computer right side up.
Lift off the top half of the case.
Step 3
Keyboard
- Near the motherboard, gently pull the keyboard ribbon cable until it becomes free.
- Lift the keyboard out of the case.
Near the motherboard, gently pull the keyboard ribbon cable until it becomes free.
Lift the keyboard out of the case.
Step 4
Motherboard
- Remove the nine 15.24 mm Phillips screws securing the motherboard in place.
- When removing the spring door, make sure to keep the door closed.
Remove the nine 15.24 mm Phillips screws securing the motherboard in place.
When removing the spring door, make sure to keep the door closed.
Step 5
- Remove the 5 jumper cables from the motherboard.
- Once the jumper cables lift the motherboard up gently; it should lift out easily.
Remove the 5 jumper cables from the motherboard.
Once the jumper cables lift the motherboard up gently; it should lift out easily.
Step 6
Power Cord
- Remove the two 1.6 inch screws securing the transformer.
Remove the two 1.6 inch screws securing the transformer.
Step 7
- Remove the power cord’s three leads from the transformer.
- Note the orientation and color of the three leads. Make sure to replace these exactely as they were.
Remove the power cord’s three leads from the transformer.
Note the orientation and color of the three leads. Make sure to replace these exactely as they were.
Step 8
- Using needle-nose pliers, pinch the tabs of the grommet holding the power cord to the case and push the grommet out.
- Remove the entire length of cord from the case and replace with a new one.
Using needle-nose pliers, pinch the tabs of the grommet holding the power cord to the case and push the grommet out.
Remove the entire length of cord from the case and replace with a new one.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
5 other people completed this guide.
Author
with 5 other contributors
Christopher Paige
Member since: 01/21/2011
549 Reputation
3 Guides authored
Badges:
11
+8 more badges
Team
Cal Poly, Team 11-24, Maness Winter 2011
Member of Cal Poly, Team 11-24, Maness Winter 2011
CPSU-MANESS-W11S11G24
4 Members
10 Guides authored