Trio Stealth G2 Hype Speakers Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

                          2 minutes            

Sections

2

• Back Panel
• 3 steps
• Speakers
• 2 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

• BackTrio Stealth G2 Hype

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Back Panel               

• Remove the two 1.2 mm Phillips #0 screws found at the side by the power button.

Remove the two 1.2 mm Phillips #0 screws found at the side by the power button.

1024

Step 2

• Using the plastic opening tool, insert it between the back panel and screen starting on the corner to the right of the power button side and begin separating the back cover.
• Be cautious when opening the back cover as it is connected through fragile wires to the speaker.

Using the plastic opening tool, insert it between the back panel and screen starting on the corner to the right of the power button side and begin separating the back cover.

Be cautious when opening the back cover as it is connected through fragile wires to the speaker.

Step 3

• Remove the speakers by using your hand to entirely disconnect the back cover.

Remove the speakers by using your hand to entirely disconnect the back cover.

Step 4

              Speakers               

• Carefully peel the tape holding down the wires connected to the speaker.

Carefully peel the tape holding down the wires connected to the speaker.

Step 5

• In order to replace the speakers after they are removed, you must solder the wires back onto the motherboard.
• The red wire must be soldered onto the “+” terminal while the black wire must be terminal must be soldered onto the “-” terminal.
• Pull the speaker and wires from the motherboard.

In order to replace the speakers after they are removed, you must solder the wires back onto the motherboard.

The red wire must be soldered onto the “+” terminal while the black wire must be terminal must be soldered onto the “-” terminal.

Pull the speaker and wires from the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Thomas Lichtenberger                     

Member since: 01/21/2015

438 Reputation

                                      3 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges                           

Team

                       USF Tampa, Team 4-4, Brown Winter 2015                        

                                                  Member of USF Tampa, Team 4-4, Brown Winter 2015 



                    USFT-BROWN-W15S4G4                     


                                            3 Members                     


                                            3 Guides authored