Difficulty

Difficult

Steps

7

Time Required

                          10 - 40 minutes

Sections

2

  • Back Cover
  • 4 steps
  • Speaker
  • 3 steps

Flags

0

  • BackTrio STEALTH-9

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • Remove the two Phillips #00 screws on the side of the tablet.

Remove the two Phillips #00 screws on the side of the tablet.

1024

Step 2

  • Take one of the plastic opening tools and wedge it in the middle of the tablet, starting on the USB Port side.
  • Holding the tool in place, take one of the 6 plastic opening picks and slide it across the opening you made with the opening tool.

Take one of the plastic opening tools and wedge it in the middle of the tablet, starting on the USB Port side.

Holding the tool in place, take one of the 6 plastic opening picks and slide it across the opening you made with the opening tool.

Step 3

  • Continue going around the tablet sides with the plastic pick, being sure that you are maintaining the openings you made with either your hand or the opening tool.
  • You will notice some popping as you go around with the pick. Don’t worry, this is completely normal.

Continue going around the tablet sides with the plastic pick, being sure that you are maintaining the openings you made with either your hand or the opening tool.

You will notice some popping as you go around with the pick. Don’t worry, this is completely normal.

Step 4

  • Remove the back cover of the tablet to reveal the internals.
  • To replace, pinch each of the ends together until all four sides are closed.

Remove the back cover of the tablet to reveal the internals.

To replace, pinch each of the ends together until all four sides are closed.

Step 5

              Speaker
  • Slowly remove the electrical tape holding down the Speaker wires.

Slowly remove the electrical tape holding down the Speaker wires.

Step 6

  • Remove the #00 screw on the Speaker mount and remove the Speaker mount.

Remove the #00 screw on the Speaker mount and remove the Speaker mount.

Step 7

  • Prepare your Soldering tools. Desolder the Speaker leads from the Motherboard.
  • Remove any excess solder as necessary, and apply new solder when replacing a Speaker.

Prepare your Soldering tools. Desolder the Speaker leads from the Motherboard.

Remove any excess solder as necessary, and apply new solder when replacing a Speaker.

To reassemble your device, follow these instructions in reverse order, making sure to be careful with your wiring leads and soldering work.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Joshua Chavis

Member since: 01/29/2015

415 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Clemson, Team 15-5, Shirley Winter 2015                        

                                                  Member of Clemson, Team 15-5, Shirley Winter 2015 



                    CLEM-SHIRLEY-W15S15G5                     


                                            5 Members                     


                                            10 Guides authored