Difficulty
Moderate
Steps
5
Time Required
Suggest a time??
Sections
2
- Back Panel
- 1 step
- Front-Facing/ Rear-Facing Camera
- 4 steps
Flags
1
Needs More Images
A few more images would make this guide’s procedures crystal clear.
BackTrio Stealth-10
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- To remove the back panel, you will need to use a plastic opening tool and slowly separate the back panel from the device.
To remove the back panel, you will need to use a plastic opening tool and slowly separate the back panel from the device.
1024
Step 2
Front-Facing/ Rear-Facing Camera
- Next use your PH 0 to remove the two 4mm screws to detach the camera support fixture.
Next use your PH 0 to remove the two 4mm screws to detach the camera support fixture.
Step 3
- Disconnect the camera from the mother board. Use a spudger and lift the grey latch until it is facing up then pull out the connection for the cameras.
Disconnect the camera from the mother board. Use a spudger and lift the grey latch until it is facing up then pull out the connection for the cameras.
Step 4
- Remove the first layer of tape above camera cable connection slowly.
Remove the first layer of tape above camera cable connection slowly.
Step 5
- Remove the second layer of tape above camera cable connection gently and remove the cameras from the device.
Remove the second layer of tape above camera cable connection gently and remove the cameras from the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 4 other contributors
Daniel Coleman
Member since: 10/29/2015
640 Reputation
5 Guides authored
Badges:
16
+13 more badges
Team
UMass Dartmouth, Team 1-4, Miles Fall 2015
Member of UMass Dartmouth, Team 1-4, Miles Fall 2015
UMASSD-MILES-F15S1G4
3 Members
12 Guides authored
