Toshiba Usb Mini Optical Scroller Mouse With Retractable Cord Pa1367U 1Nms Disassembly Repair Guide

Difficulty

Very easy

Steps

3

Time Required

                          1 minute            

Sections

1

• TOSHIBA USB Mini Optical Scroller Mouse with Retractable Cord PA1367U-1NMS Disassembly
• 3 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackTOSHIBA USB Mini Optical Scroller Mouse with Retractable Cord PA1367U-1NMS

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              TOSHIBA USB Mini Optical Scroller Mouse with Retractable Cord PA1367U-1NMS Disassembly               

• There are three cross head screws– two at the top and one at the bottom. you will need a size 0 phillips head screwdriver to take them out.

There are three cross head screws– two at the top and one at the bottom. you will need a size 0 phillips head screwdriver to take them out.

1024

Step 2

• Once you turn over the mouse you can lift the casing off and have access to the components on the top of the circuit board.

Once you turn over the mouse you can lift the casing off and have access to the components on the top of the circuit board.

Step 3

• To be able to un-solder any components on the circuit board you can slowly but firmly detach the wire from its holder.
• Once the wire is detached from its holder you may gently pull the circuit board vertically from the plastic housing.
• Be careful not to pull the circuit board horizontally from the housing or else you will break off the plastic pins holding the circuit board of the plastic.

To be able to un-solder any components on the circuit board you can slowly but firmly detach the wire from its holder.

Once the wire is detached from its holder you may gently pull the circuit board vertically from the plastic housing.

Be careful not to pull the circuit board horizontally from the housing or else you will break off the plastic pins holding the circuit board of the plastic.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    A G                     

Member since: 04/26/2019

97 Reputation

                                      1 Guide authored                  



                       Badges:
                       1