Difficulty
Moderate
Steps
5
Time Required
15 minutes
Sections
2
- Battery
- 2 steps
- RAM
- 3 steps
Flags
0
BackToshiba Tecra 8200
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Turn off the device and unplug the power cord.
- To remove the battery, flip the device, so that the bottom is facing upward.
Turn off the device and unplug the power cord.
To remove the battery, flip the device, so that the bottom is facing upward.
1024
Step 2
- Slide the battery to the right side until you hear a click.
- Carefully remove the battery from its compartment.
Slide the battery to the right side until you hear a click.
Carefully remove the battery from its compartment.
Step 3
RAM
- Position device so the screen is face down.
- Locate RAM Panel.
Position device so the screen is face down.
Locate RAM Panel.
Step 4
- Remove two Phillips #00 screws labeled F4.
- Remove panel.
Remove two Phillips #00 screws labeled F4.
Remove panel.
Step 5
- Pinch clips on each side of RAM chips to release.
- Gently remove RAM chips at a 45 degree angle. Use a plastic opening tool if RAM chips do not pop open.
Pinch clips on each side of RAM chips to release.
Gently remove RAM chips at a 45 degree angle. Use a plastic opening tool if RAM chips do not pop open.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 7 other contributors
Sally
Member since: 02/17/2015
306 Reputation
3 Guides authored
Badges:
3
Team
Ohio State, Team 1-3, Buehl Winter 2015
Member of Ohio State, Team 1-3, Buehl Winter 2015
OSU-BUEHL-W15S1G3
3 Members
6 Guides authored