Difficulty
Easy
Steps
4
Time Required
15 - 20 minutes
Sections
1
- RAM
- 4 steps
Flags
0
BackToshiba Satellite U925T-S2120
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
RAM
- Remove the 9 rubber gripper pads on the back panel of the laptop using tweezers.
Remove the 9 rubber gripper pads on the back panel of the laptop using tweezers.
1024
Step 2
- Unscrew nine 5.8 mm screws by turning a PH1 screwdriver clockwise after inserting it into the screw.
- Unscrew two 6.8 mm screws by turning a PH1 screwdriver clockwise after inserting it into the screw.
Unscrew nine 5.8 mm screws by turning a PH1 screwdriver clockwise after inserting it into the screw.
Unscrew two 6.8 mm screws by turning a PH1 screwdriver clockwise after inserting it into the screw.
Step 3
- Take off the back panel open by sticking the plastic opening tool into the seam of the laptop, and pushing the opening tool downwards.
Take off the back panel open by sticking the plastic opening tool into the seam of the laptop, and pushing the opening tool downwards.
Step 4
- Gently pinch the RAM with your thumb and pointer finger.
- Pull the RAM out of the logic board with gentle force.
- Try to keep the RAM parallel as you pull it out, so that the RAM does not chip.
Gently pinch the RAM with your thumb and pointer finger.
Pull the RAM out of the logic board with gentle force.
Try to keep the RAM parallel as you pull it out, so that the RAM does not chip.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 3 other contributors
Andrew Honderich
Member since: 03/29/2017
364 Reputation
3 Guides authored
Badges:
7
+4 more badges
Team
Baylor, Team S5-G5, Williams Spring 2017
Member of Baylor, Team S5-G5, Williams Spring 2017
BU-WILLIAMS-S17S5G5
3 Members
5 Guides authored
