Difficulty
Moderate
Steps
7
Time Required
30 minutes
Sections
1
- Display
- 7 steps
Flags
4
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
Markup Mishap
This guide needs better markups. Help out by correcting or making some markup annotations.
Missing Prerequisites
This guide is missing information on how to start the process. Make a prerequisite guide!
Better Introduction
Improve this guide by completing or revising its introduction.
BackToshiba Satellite U405D-S2902
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Display
- Use tweezers to remove the small rubber covers over the screws on the top and bottom of the laptop case.
Use tweezers to remove the small rubber covers over the screws on the top and bottom of the laptop case.
1024
Step 2
- Use a #1 Phillips screwdriver to remove the 3mm screws located on both sides of the top of the laptop as well as the lower corners.
Use a #1 Phillips screwdriver to remove the 3mm screws located on both sides of the top of the laptop as well as the lower corners.
Step 3
- Use a plastic opening tool to separate the front plastic panel from the back side of the top of the laptop.
- Carefully pull the top away from the back.
Use a plastic opening tool to separate the front plastic panel from the back side of the top of the laptop.
Carefully pull the top away from the back.
Step 4
- Turn the laptop around.
- Remove the webcam/microphone data cable.
Turn the laptop around.
Remove the webcam/microphone data cable.
Step 5
- Remove the lower lighting power supply.
- Remove the signal light power supply and data cable.
Remove the lower lighting power supply.
Remove the signal light power supply and data cable.
Step 6
- Locate and remove the four 2mm #1 Phillips screws around the sidewalls of the display.
- After removing the last screw, the screen will be very loose, be sure to keep a hand on it to prevent it from damaging the keyboard.
Locate and remove the four 2mm #1 Phillips screws around the sidewalls of the display.
After removing the last screw, the screen will be very loose, be sure to keep a hand on it to prevent it from damaging the keyboard.
Step 7
- Carefully remove the screen from the side brackets.
- Remove the LCD ribbon connector from the display.
Carefully remove the screen from the side brackets.
Remove the LCD ribbon connector from the display.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 7 other contributors
Brandon Kirklen
Member since: 01/11/2013
311 Reputation
8 Guides authored
Badges:
12
+9 more badges
Team
Cal Poly, Team 7-8, Maness Winter 2013
Member of Cal Poly, Team 7-8, Maness Winter 2013
CPSU-MANESS-W13S7G8
4 Members
8 Guides authored