Difficulty
Moderate
Steps
9
Time Required
20 minutes
Sections
1
- Hard Drive
- 9 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackToshiba Satellite S75D-A7346
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Taking Out The Battery
- First we have to take out the battery
- Pull the switch on the left to the left
- then hold the switch on the right to the right direction
- then pull up the bttery from the point inbetween the 2 switches
First we have to take out the battery
Pull the switch on the left to the left
then hold the switch on the right to the right direction
then pull up the bttery from the point inbetween the 2 switches
1024
Step 2
UnScrewing The BackPlate
- Unscrew the screw located next to the information sticker
- Then get a screw driver or prier to gently pry the covering plate
Unscrew the screw located next to the information sticker
Then get a screw driver or prier to gently pry the covering plate
Step 3
Taking Out The HDD
- Unscrew the black screws and then pull the black tab to the right
- Then lift it out and place it somewhere
Unscrew the black screws and then pull the black tab to the right
Then lift it out and place it somewhere
Step 4
Taking The HDD Of the Mount
- Unscrew the silver screws and move the hard drive somewhere else
Unscrew the silver screws and move the hard drive somewhere else
Step 5
Adding The New HDD/SSD To The Mount
- Screw the silver screws into the screw slots furthest away from the connectors
- Note: This computer is only compatible with 2.5 inch SATA 3Gbps
Screw the silver screws into the screw slots furthest away from the connectors
Note: This computer is only compatible with 2.5 inch SATA 3Gbps
Step 6
Connecting The HDD/SSD
- Put the Hard Drive in slot (make sure the connectors are on the same side of the connectors
- Push the Hard Driver into the connector and screw the black screws in
Put the Hard Drive in slot (make sure the connectors are on the same side of the connectors
Push the Hard Driver into the connector and screw the black screws in
Step 7
Putting On The Backplate
- Put on the backplate and put pressure arround the edges of the blackplate so it stays flat with the case
- Then screw in the screw next to the information sticker
Put on the backplate and put pressure arround the edges of the blackplate so it stays flat with the case
Then screw in the screw next to the information sticker
Step 8
Putting In The Battery
- Place the battery in the slot
- Then hold the right switch to the right and push the battery in, then release the switch.
- move the left switch to the right
Place the battery in the slot
Then hold the right switch to the right and push the battery in, then release the switch.
move the left switch to the right
Step 9
You Finished
- You have know finished the replacement
You have know finished the replacement
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Emil Lambert
Member since: 12/16/2016
228 Reputation
2 Guides authored
Badges:
4
+1 more badge