Difficulty

Moderate

Steps

6

Time Required

                          15 - 20 minutes

Sections

2

  • Battery
  • 1 step
  • Disk Drive
  • 5 steps

Flags

0

  • BackToshiba Satellite P855-S5312

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Turn laptop upside down with the spine facing towards you and locate the two tabs on the top of the back panel.
  • Move the sliders to the left and right to release the tabs holding the battery in.
  • While the tabs are pushed outwards, remove the battery from the device.

Turn laptop upside down with the spine facing towards you and locate the two tabs on the top of the back panel.

Move the sliders to the left and right to release the tabs holding the battery in.

While the tabs are pushed outwards, remove the battery from the device.

1024

Step 2

              Disk Drive
  • Once laptop is turned over with the spine facing you, locate the large L shape panel.
  • Using a Philips #0 screwdriver unscrew the 1.5mm screw towards the bottom of the laptop.

Once laptop is turned over with the spine facing you, locate the large L shape panel.

Using a Philips #0 screwdriver unscrew the 1.5mm screw towards the bottom of the laptop.

Step 3

  • Open the motherboard access cover.

Open the motherboard access cover.

Step 4

  • Using a Philips #0 screwdriver, unscrew the 1.5mm screw located near the left edge of the opening near the mother board.

Using a Philips #0 screwdriver, unscrew the 1.5mm screw located near the left edge of the opening near the mother board.

Step 5

  • Gently pull the entire disk drive assembly out.

Gently pull the entire disk drive assembly out.

Step 6

  • Flip your device over and rotate the side of the optical drive over to you.
  • Unclip the clips on the side of the automatic release.
  • Use a paper clip or small needle tool to insert in the manual release located on the right of the automatic release button.
  • Once released slide the aluminum case out.

Flip your device over and rotate the side of the optical drive over to you.

Unclip the clips on the side of the automatic release.

Use a paper clip or small needle tool to insert in the manual release located on the right of the automatic release button.

Once released slide the aluminum case out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Bishop Clark

Member since: 10/02/2017

217 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       USF Tampa, Team S10-G2, Thompson Fall 2017                        

                                                  Member of USF Tampa, Team S10-G2, Thompson Fall 2017 



                    USFT-THOMPSON-F17S10G2                     


                                            3 Members                     


                                            6 Guides authored