Difficulty

Easy

Steps

6

Time Required

                          10 minutes

Sections

2

  • Battery
  • 5 steps
  • RAM
  • 1 step

Flags

0

  • BackToshiba Satellite P55W-C5200X

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

All tools that will be needed are listed below to gain access and change out your devices RAM. This is a very simple process and low risk as well, the only advise would be to make sure the device is turned off and to be careful when handling the RAM and the slots they go into.

This guide will tell Toshiba Satellite P55W-C5200X users how to replace there RAM. It is an easy-level process that takes 5-10 minutes to complete.

What you need

Step 1

              Battery
  • Use the Phillips #00 screwdriver to remove the ten 4.0 mm screws located at the bottom of the laptop.

Use the Phillips #00 screwdriver to remove the ten 4.0 mm screws located at the bottom of the laptop.

1024

Step 2

  • Use the black nylon spudger to pry the back casing along the edges.
  • Continue to pry along the edge of the back case until the back is ready to be removed.

Use the black nylon spudger to pry the back casing along the edges.

Continue to pry along the edge of the back case until the back is ready to be removed.

Step 3

  • Remove the four 6.0 mm screws that hold the battery in place using the JIS #000 screwdriver.

Remove the four 6.0 mm screws that hold the battery in place using the JIS #000 screwdriver.

Step 4

  • Disconnect the battery cable from the motherboard by carefully pulling on the black wire at the point closest to the white tab.

Disconnect the battery cable from the motherboard by carefully pulling on the black wire at the point closest to the white tab.

Step 5

  • Gently remove the battery from your device.

Gently remove the battery from your device.

Step 6

              RAM
  • For this particular model of the device there will be two sticks of RAM.
  • There are two metal brackets holding each RAM stick in place. Carefully move the metal brackets outward on both sides at the same time.
  • Pull the RAM sticks out.

For this particular model of the device there will be two sticks of RAM.

There are two metal brackets holding each RAM stick in place. Carefully move the metal brackets outward on both sides at the same time.

Pull the RAM sticks out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Hadi Termos

Member since: 10/21/2019

238 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       UMass Dartmouth, Team S1-G2, Botvin Fall 2019                        

                                                  Member of UMass Dartmouth, Team S1-G2, Botvin Fall 2019 



                    UMASSD-BOTVIN-F19S1G2                     


                                            4 Members                     


                                            10 Guides authored